Re: [PATCH 2/3] doc,dts - add XRA1403 DTS binding documentation

[Rob Herring]

On Mon, Mar 27, 2017 at 09:23:01AM +0300, Nandor Han wrote:
> Add the XRA1403 DTS binding documentation.

"dt-bindings: gpio: ..." for the subject prefix please.

> 
> Signed-off-by: Nandor Han <nandor.han@xxxxxx>
> ---
>  .../devicetree/bindings/gpio/gpio-xra1403.txt      | 37 ++++++++++++++++++++++
>  1 file changed, 37 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/gpio/gpio-xra1403.txt
> 
> diff --git a/Documentation/devicetree/bindings/gpio/gpio-xra1403.txt b/Documentation/devicetree/bindings/gpio/gpio-xra1403.txt
> new file mode 100644
> index 0000000..ccf5337
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/gpio-xra1403.txt
> @@ -0,0 +1,37 @@
> +GPIO Driver for XRA1403 16-BIT GPIO Expander With Reset Input from EXAR
> +
> +The XRA1403 is an 16-bit GPIO expander with an SPI interface. Features available:
> +	- Individually programmable inputs:
> +		- Internal pull-up resistors
> +		- Polarity inversion
> +		- Individual interrupt enable
> +		- Rising edge and/or Falling edge interrupt
> +		- Input filter
> +	- Individually programmable outputs
> +		- Output Level Control
> +		- Output Three-State Control
> +
> +Properties
> +----------
> +Check documentation for SPI and GPIO controllers regarding properties needed to configure the node.
> +
> +	- compatible = "exar,xra1403".
> +	- reg = SPI id of the device.
> +	- gpio-controller: mark the node as gpio.

#gpio-cells?

> +
> +Optional properties:
> +-------------------
> +	- reset-gpios: in case available used to control the device reset line.
> +
> +Example
> +--------
> +
> +	gpioxra0: gpio@2 {
> +		compatible = "exar,xra1403";
> +		reg = <2>;
> +		gpio-controller;
> +		#gpio-cells = <2>;
> +		reset-gpios = <&gpio3 6 GPIO_ACTIVE_LOW>;
> +		spi-max-frequency = <1000000>;
> +		status = "okay";

Don't show status in examples.

> +	};
> -- 
> 2.10.1
>