[RFC PATCH] sata_via: Enable hotplug on VT6420

[Ondrej Zary]

VT6420 seems to have the same hotplug capability as VT6421.

However, enabling hotplug needs to expose SCR registers which can cause
problems. It works for me but might break elsewhere.

---
 drivers/ata/sata_via.c |   10 ++++++----
 1 file changed, 6 insertions(+), 4 deletions(-)

diff --git a/drivers/ata/sata_via.c b/drivers/ata/sata_via.c
index f3f538e..fafb0d3 100644
--- a/drivers/ata/sata_via.c
+++ b/drivers/ata/sata_via.c
@@ -132,6 +132,8 @@ struct svia_priv {
 
 static struct ata_port_operations vt6420_sata_ops = {
 	.inherits		= &svia_base_ops,
+	.scr_read		= svia_scr_read,
+	.scr_write		= svia_scr_write,
 	.freeze			= svia_noop_freeze,
 	.prereset		= vt6420_prereset,
 	.bmdma_start		= vt6420_bmdma_start,
@@ -556,7 +558,7 @@ static void svia_wd_fix(struct pci_dev *pdev)
 	pci_write_config_byte(pdev, 0x52, tmp8 | BIT(2));
 }
 
-static irqreturn_t vt6421_interrupt(int irq, void *dev_instance)
+static irqreturn_t vt642x_interrupt(int irq, void *dev_instance)
 {
 	struct ata_host *host = dev_instance;
 	irqreturn_t rc = ata_bmdma_interrupt(irq, dev_instance);
@@ -644,7 +646,7 @@ static void svia_configure(struct pci_dev *pdev, int board_id,
 		pci_write_config_byte(pdev, SATA_NATIVE_MODE, tmp8);
 	}
 
-	if (board_id == vt6421) {
+	if (board_id == vt6420 || board_id == vt6421) {
 		/* enable IRQ on hotplug */
 		pci_read_config_byte(pdev, SVIA_MISC_3, &tmp8);
 		if ((tmp8 & SATA_HOTPLUG) != SATA_HOTPLUG) {
@@ -744,8 +746,8 @@ static int svia_init_one(struct pci_dev *pdev, const struct pci_device_id *ent)
 	svia_configure(pdev, board_id, hpriv);
 
 	pci_set_master(pdev);
-	if (board_id == vt6421)
-		return ata_host_activate(host, pdev->irq, vt6421_interrupt,
+	if (board_id == vt6420 || board_id == vt6421)
+		return ata_host_activate(host, pdev->irq, vt642x_interrupt,
 					 IRQF_SHARED, &svia_sht);
 	else
 		return ata_host_activate(host, pdev->irq, ata_bmdma_interrupt,
-- 
Ondrej Zary