RE: [PATCH v4 0/9] Renesas RZ/A1 pin and gpio controller

[Chris Brandt]

Hi Jacopo,

On Wednesday, April 05, 2017, Jacopo Mondi wrote:
> v3 -> v4:
> - use "pinmux" property in pmx sub-nodes in place of "renesas,pins"
> - use pinconf standard properties to set pin mux additional flags
> - add "bi-directional" and "output-enable" to pinconf generic properties
> - perform pmx function parsing at dt_node_to_map() time
> - change DT bindings to use GENERIC_PINCONF
> - change DT bindings to allow sub-nodes to have "pinmux" property
> specified
> - several renames (register names, DT parse functions, set_mux() function)


I just tested this driver on the RZ/A1 RSK board.
The following worked good.

   SCIF2, I2C, SDHI, Ethernet


SDHI also has bi-direction pins. For your reference, here was my DT:


	/* SHDI ch1 on CN1 */
	sdhi1_pins: sdhi1 {
		pins {
			pinmux = <RZA1_PINMUX(3, 8, 7)>,	/* SD_CD_1 */
				 <RZA1_PINMUX(3, 9, 7)>,	/* SD_WP_1 */
				 <RZA1_PINMUX(3, 12, 7)>,	/* SD_CLK_1 */
				 <RZA1_PINMUX(3, 13, 7)>;	/* SD_CMD_1 */
		};

		pins_bidir {
			pinmux = <RZA1_PINMUX(3, 10, 7)>,	/* SD_D1_1 */
				 <RZA1_PINMUX(3, 11, 7)>,	/* SD_D0_1 */
				 <RZA1_PINMUX(3, 14, 7)>,	/* SD_D3_1 */
				 <RZA1_PINMUX(3, 15, 7)>;	/* SD_D2_1 */
			bi-directional;
		};
	};


Thanks,
Chris