Re: [PATCH v3] lightnvm: physical block device (pblk) target
From: Bart Van Assche
Date: Mon Apr 10 2017 - 11:56:04 EST
On Sun, 2017-04-09 at 11:15 +0200, Javier González wrote:
> On 8 Apr 2017, at 22.56, Bart Van Assche <bart.vanassche@xxxxxxxxxxx> wrote:
> > On 04/07/17 11:50, Javier González wrote:
> struct ppa_addr, which is the physical address format is not affected,
> but pblk's internal L2P address representation (pblk_addr) is. You can
> see that the type either represents struct ppa_addr or ppa_addr_32. How
> would you define a type that can either be u64 or u32 with different bit
> offsets at run-time? Note that address conversions to this type is in
> the fast path and this format allows us to only use bit shifts.
Selecting the appropriate representation at run-time would require to pass
pblk_addr by reference instead of by value to any function that expects a
pblk_addr. It would also require to have two versions of every data structure
that depends on pblk_addr and to use casts to convert to the appropritate
version. However, this approach is probably only worth to be implemented if
it doesn't introduce too much additional complexity.
> > > +#ifdef CONFIG_NVM_DEBUG
> > > + atomic_add(nr_entries, &pblk->inflight_writes);
> > > + atomic_add(nr_entries, &pblk->req_writes);
> > > +#endif
> >
> > Has it been considered to use the "static key" feature such that
> > consistency checks can be enabled at run-time instead of having to
> > rebuild the kernel to enable CONFIG_NVM_DEBUG?
>
> I haven't considered it. I'll look into it. I would like to have this
> counters and the corresponding sysfs entry only available on debug mode
> since it allows us to have a good picture of the FTL state.
If there are sysfs entries that depend on CONFIG_NVM_DEBUG then the static
key mechanism is probably not a good alternative for CONFIG_NVM_DEBUG.
> > Has it been considered to add support for keeping a subset of the L2P
> > translation table in memory instead of keeping it in memory in its entirety?
>
> Yes. L2P caching is on our roadmap and will be included in the future.
That's great. This will also help with reducing the time between discovery of
a lightnvm device and the time at which I/O can start since the L2P table must
be available before I/O can start.
Bart.