[PATCH V2 16/17] thermal: cpu_cooling: 'freq' can't be zero in cpufreq_state2power()

[Viresh Kumar]

The frequency table shouldn't have any zero frequency entries and so
such a check isn't required. Though it would be better to make sure
'state' is within limits.

Signed-off-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>
---
 drivers/thermal/cpu_cooling.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/thermal/cpu_cooling.c b/drivers/thermal/cpu_cooling.c
index 1e4c5d13afbf..dfc3638ea939 100644
--- a/drivers/thermal/cpu_cooling.c
+++ b/drivers/thermal/cpu_cooling.c
@@ -560,12 +560,13 @@ static int cpufreq_state2power(struct thermal_cooling_device *cdev,
 	int ret;
 	struct cpufreq_cooling_device *cpufreq_cdev = cdev->devdata;
 
+	/* Request state should be less than max_level */
+	if (WARN_ON(state > cpufreq_cdev->max_level))
+		return -EINVAL;
+
 	num_cpus = cpumask_weight(cpufreq_cdev->policy->cpus);
 
 	freq = cpufreq_cdev->freq_table[state].frequency;
-	if (!freq)
-		return -EINVAL;
-
 	dynamic_power = cpu_freq_to_power(cpufreq_cdev, freq) * num_cpus;
 	ret = get_static_power(cpufreq_cdev, tz, freq, &static_power);
 	if (ret)
-- 
2.12.0.432.g71c3a4f4ba37