Re: [PATCH v2 1/3] cpufreq: Add Tegra186 cpufreq driver

[Rafael J. Wysocki]

On Tuesday, April 11, 2017 09:37:28 AM Mikko Perttunen wrote:
> On 04/11/2017 09:35 AM, Viresh Kumar wrote:
> > On 04-04-17, 16:43, Mikko Perttunen wrote:
> >> Add a new cpufreq driver for Tegra186 (and likely later).
> >> The CPUs are organized into two clusters, Denver and A57,
> >> with two and four cores respectively. CPU frequency can be
> >> adjusted by writing the desired rate divisor and a voltage
> >> hint to a special per-core register.
> >>
> >> The frequency of each core can be set individually; however,
> >> this is just a hint as all CPUs in a cluster will run at
> >> the maximum rate of non-idle CPUs in the cluster.
> >>
> >> Signed-off-by: Mikko Perttunen <mperttunen@xxxxxxxxxx>
> >> ---
> >> v2:
> >> - Many cosmetic / restructuring changes
> >> - Only one aperture read from DT now, with a new
> >>   structure containing the offset among other details
> >>   per cluster.
> >> - Don't enable the driver by default.
> >>
> >>  drivers/cpufreq/Kconfig.arm        |   6 +
> >>  drivers/cpufreq/Makefile           |   1 +
> >>  drivers/cpufreq/tegra186-cpufreq.c | 275 +++++++++++++++++++++++++++++++++++++
> >>  3 files changed, 282 insertions(+)
> >>  create mode 100644 drivers/cpufreq/tegra186-cpufreq.c
> >
> > For all three patches.
> >
> > Acked-by: Viresh Kumar <viresh.kumar@xxxxxxxxxx>

I've applied the [1/3], but ACKs from the DT maintainers are needed for the
other two.

Thanks,
Rafael