Re: [PATCH net-next v3] bindings: net: stmmac: add missing note about LPI interrupt

[Giuseppe CAVALLARO]

On 4/18/2017 2:39 PM, Niklas Cassel wrote:
> From: Niklas Cassel <niklas.cassel@xxxxxxxx>
>
> The hardware has a LPI interrupt.
> There is already code in the stmmac driver to parse and handle the
> interrupt. However, this information was missing from the DT binding.
>
> At the same time, improve the description of the existing interrupts.
>
> Signed-off-by: Niklas Cassel <niklas.cassel@xxxxxxxx>
> ---
>   Documentation/devicetree/bindings/net/stmmac.txt | 13 ++++++++-----
>   1 file changed, 8 insertions(+), 5 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/net/stmmac.txt b/Documentation/devicetree/bindings/net/stmmac.txt
> index f652b0c384ce..c3a7be6615c5 100644
> --- a/Documentation/devicetree/bindings/net/stmmac.txt
> +++ b/Documentation/devicetree/bindings/net/stmmac.txt
> @@ -7,9 +7,12 @@ Required properties:
>   - interrupt-parent: Should be the phandle for the interrupt controller
>     that services interrupts for this device
>   - interrupts: Should contain the STMMAC interrupts
> -- interrupt-names: Should contain the interrupt names "macirq"
> -  "eth_wake_irq" if this interrupt is supported in the "interrupts"
> -  property
> +- interrupt-names: Should contain a list of interrupt names corresponding to
> +	the interrupts in the interrupts property, if available.
> +	Valid interrupt names are:
> +  - "macirq" (combined signal for various interrupt events)
> +  - "eth_wake_irq" (the interrupt to manage the remote wake-up packet detection)
> +  - "eth_lpi" (the interrupt that occurs when Tx or Rx enters/exits LPI state)
>   - phy-mode: See ethernet.txt file in the same directory.
>   - snps,reset-gpio 	gpio number for phy reset.
>   - snps,reset-active-low boolean flag to indicate if phy reset is active low.
> @@ -152,8 +155,8 @@ Examples:
>   		compatible = "st,spear600-gmac";
>   		reg = <0xe0800000 0x8000>;
>   		interrupt-parent = <&vic1>;
> -		interrupts = <24 23>;
> -		interrupt-names = "macirq", "eth_wake_irq";
> +		interrupts = <24 23 22>;
> +		interrupt-names = "macirq", "eth_wake_irq", "eth_lpi";
>   		mac-address = [000000000000]; /* Filled in by U-Boot */
>   		max-frame-size = <3800>;
>   		phy-mode = "gmii";

Acked-by: Giuseppe Cavallaro <peppe.cavallaro@xxxxxx>