[usb-gadget-udc] question about null check after calling phys_to_virt() function

[Gustavo A. R. Silva]

Hello everybody,

While looking into Coverity ID 145958 I ran into the following piece  
of code at drivers/usb/gadget/udc/amd5536udc.c:852:

} else if (i == buf_len) {
        /* first td */
        td = (struct udc_data_dma *)phys_to_virt(
                                req->td_data->next);
        td->status = 0;
} else {
        td = (struct udc_data_dma *)phys_to_virt(last->next);
        td->status = 0;
}

if (td)
        td->bufptr = req->req.dma + i; /* assign buffer */
else
        break;

The issue here is that _td_ pointer is being dereferenced before null check.

After searching for calls to phys_to_virt() function, I've noticed  
that is not common at all to test the returned address value.

So either the null check at line 862 is not needed or a null check  
before each td->status = 0; needs to be added.

I think it would be good to apply a patch like the following one:

-                       td->status = 0;
+
+                       if (td)
+                               td->status = 0;
+                       else
+                               break;
                } else {
                        td = (struct udc_data_dma *)phys_to_virt(last->next);
-                       td->status = 0;
+
+                       if (td)
+                               td->status = 0;
+                       else
+                               break;
                }

-               if (td)
-                       td->bufptr = req->req.dma + i; /* assign buffer */
-               else
-                       break;
+               td->bufptr = req->req.dma + i; /* assign buffer */


What do you think?

Thanks in advance for your comments
--
Gustavo A. R. Silva