[PATCH v2 06/11] arm64: dts: Add NAND DT nodes for Stingray SOC

[Anup Patel]

From: Pramod Kumar <pramod.kumar@xxxxxxxxxxxx>

This patch adds NAND controller DT Node and NAND chip DT
node for Stingray SOC and Stingray reference boards.

Signed-off-by: Pramod Kumar <pramod.kumar@xxxxxxxxxxxx>
Signed-off-by: Abhishek Shah <abhishek.shah@xxxxxxxxxxxx>
Reviewed-by: Vikram Prakash <vikram.prakash@xxxxxxxxxxxx>
Reviewed-by: Ray Jui <ray.jui@xxxxxxxxxxxx>
Reviewed-by: Scott Branden <scott.branden@xxxxxxxxxxxx>
---
 arch/arm64/boot/dts/broadcom/stingray/bcm958742-base.dtsi | 15 +++++++++++++++
 arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi       | 13 +++++++++++++
 2 files changed, 28 insertions(+)

diff --git a/arch/arm64/boot/dts/broadcom/stingray/bcm958742-base.dtsi b/arch/arm64/boot/dts/broadcom/stingray/bcm958742-base.dtsi
index 0a427da..ce46224 100644
--- a/arch/arm64/boot/dts/broadcom/stingray/bcm958742-base.dtsi
+++ b/arch/arm64/boot/dts/broadcom/stingray/bcm958742-base.dtsi
@@ -56,3 +56,18 @@
 &uart1 {
 	status = "okay";
 };
+
+&nand {
+	status = "ok";
+	nandcs@0 {
+		compatible = "brcm,nandcs";
+		reg = <0>;
+		nand-ecc-mode = "hw";
+		nand-ecc-strength = <8>;
+		nand-ecc-step-size = <512>;
+		nand-bus-width = <16>;
+		brcm,nand-oob-sector-size = <16>;
+		#address-cells = <1>;
+		#size-cells = <1>;
+	};
+};
diff --git a/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi b/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
index 24856e3..c5493e7 100644
--- a/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
+++ b/arch/arm64/boot/dts/broadcom/stingray/stingray.dtsi
@@ -312,5 +312,18 @@
 			compatible = "brcm,iproc-rng200";
 			reg = <0x00220000 0x28>;
 		};
+
+		nand: nand@68c60000 {
+			compatible = "brcm,nand-iproc", "brcm,brcmnand-v6.1";
+			reg = <0x00360000 0x600>,
+			      <0x0050a408 0x600>,
+			      <0x00360f00 0x20>;
+			reg-names = "nand", "iproc-idm", "iproc-ext";
+			interrupts = <GIC_SPI 203 IRQ_TYPE_LEVEL_HIGH>;
+			#address-cells = <1>;
+			#size-cells = <0>;
+			brcm,nand-has-wp;
+			status = "disabled";
+		};
 	};
 };
-- 
2.7.4