Re: [RFC/RFT PATCH v2 3/3] PCI/ACPI: Add ACPI pci_bus_find_numa_node() implementation

[Robert Richter]

On 17.05.17 17:04:24, Lorenzo Pieralisi wrote:
> On Wed, May 17, 2017 at 04:35:58PM +0200, Robert Richter wrote:
> > On 17.05.17 14:46:54, Lorenzo Pieralisi wrote:
> > 
> > > More explicitly, I think the whole series should work also with the diff
> > > below applied on top of it. Side note: for consistency, I do not think
> > > that adding a DT counterpart to pci_bus_find_numa_node() would hurt.
> > > 
> > > Thanks !
> > > Lorenzo
> > > 
> > > -- >8 --
> > > diff --git a/drivers/pci/probe.c b/drivers/pci/probe.c
> > > index 76c089f..cf0692c 100644
> > > --- a/drivers/pci/probe.c
> > > +++ b/drivers/pci/probe.c
> > > @@ -862,7 +862,7 @@ static struct pci_bus *pci_alloc_child_bus(struct pci_bus *parent,
> > >  	 */
> > >  	child->dev.class = &pcibus_class;
> > >  	dev_set_name(&child->dev, "%04x:%02x", pci_domain_nr(child), busnr);
> > > -	set_dev_node(&child->dev, dev_to_node(&parent->dev));
> > > +
> > 
> > Hmm, in device_add() there is already:
> > 
> > 	/* use parent numa_node */
> > 	if (parent && (dev_to_node(dev) == NUMA_NO_NODE))
> >         	set_dev_node(dev, dev_to_node(parent));
> > 
> > So there are cases where the device has a different node than the
> > parent. I am not sure if we can assume for pci that it maps always.
> > 
> > And since device_add() is called later anyway, the above change might
> > not necessary at all.
> 
> That's why I _removed_ the set_dev_node() in the diff above (that applies
> to patch (2)), I do not think it is a) correct and b) necessary to
> propagate the NUMA node from bus to a child bus given that device_add()
> takes care of that already.

Ah, right, you removed it instead.

> 
> I should post a v3 (with the diff above applied) so that we are all on
> the same page and we can test it.
> 
> > But at least we must assign the node id to the
> > bridge, which is the parent. Maybe just have in
> > acpi_pci_root_create():
> > 
> > 	bridge = get_device(bus->bridge);
> > 	adev = to_acpi_device_node(bridge->fwnode);
> > 	set_dev_node(bridge, acpi_get_node(adev->handle));
> 
> I do not think that's enough, I need to check again but I think that
> also the bus->dev should have its NUMA node set for things to work (and
> allow the NUMA node to propagate correctly through device_add())
> otherwise pcibus_to_node() would fail for devices sitting on the root
> bus, right ?

Yeah, maybe another hop is in between and the node id for bus->dev is
used. Which need to be set then.

> 
> I will check again and post v3 shortly.

Thanks,

-Robert