[PATCH 0/6] Extend mvebu gpio driver to support the controllers of the Marvell Armada 7K/8K
From: Gregory CLEMENT
Date: Fri May 19 2017 - 12:09:46 EST
This series extends the mvebu gpio driver to support the gpio
controllers found on the Marvell Armada 7K/8K SoCs.
The gpio controllers used on the Marvell Armada 7K/8K SoCs are the
same that the ones used on the ARM32 mvebu SoCs. However, the pinctrl
node in the device tree of theses SoCs are child of a syscon. So the
driver has been converted to use the regamp in patch 2.
Then the remaining patches adds the support for the Armada 7K/8K SoCs.
All the patches can be merged through the gpio subsystem expect the
last that must be go through the mvebu subsystem.
Not that currently I didn't manage to fully test the gpio, indeed I
only have a 7040 DB board which lack of test point for this kind of
test. So any tested-by would be welcome.
Gregory CLEMENT (5):
gpio: mvebu: sort header include
gpio: dt-bindings: Add documentation for gpio controllers on Armada 7K/8K
gpio: mvebu: allow building driver for Armada 7K/8K
gpio: mvebu: Add support for the Armada 7K/8K SoCs
arm64: dts: marvell: add gpio support for Armada 7K/8K
Thomas Petazzoni (1):
gpio: mvebu: switch to regmap for register access
Documentation/devicetree/bindings/arm/marvell/ap806-system-controller.txt | 20 +++-
Documentation/devicetree/bindings/arm/marvell/cp110-system-controller0.txt | 24 ++-
Documentation/devicetree/bindings/gpio/gpio-mvebu.txt | 24 ++-
arch/arm64/boot/dts/marvell/armada-70x0.dtsi | 15 ++-
arch/arm64/boot/dts/marvell/armada-80x0.dtsi | 16 ++-
arch/arm64/boot/dts/marvell/armada-ap806.dtsi | 10 +-
arch/arm64/boot/dts/marvell/armada-cp110-master.dtsi | 21 +++-
arch/arm64/boot/dts/marvell/armada-cp110-slave.dtsi | 22 +++-
drivers/gpio/Kconfig | 2 +-
drivers/gpio/gpio-mvebu.c | 540 ++++++++++++++++++++++++++++++++++++++++++++----------------------------
10 files changed, 477 insertions(+), 217 deletions(-)