Re: [PATCH v3 02/10] gpio-exar/8250-exar: Do not even instantiate a GPIO device for Commtech cards

[Andy Shevchenko]

On Fri, May 26, 2017 at 7:02 PM, Jan Kiszka <jan.kiszka@xxxxxxxxxxx> wrote:
> Commtech adapters need the MPIOs for internal purposes, and the
> gpio-exar driver already refused to pick them up. But there is actually
> no point in even creating the underlying platform device.

FWIW:
Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>

> Signed-off-by: Jan Kiszka <jan.kiszka@xxxxxxxxxxx>
> ---
>  drivers/gpio/gpio-exar.c            | 3 ---
>  drivers/tty/serial/8250/8250_exar.c | 4 +++-
>  2 files changed, 3 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/gpio/gpio-exar.c b/drivers/gpio/gpio-exar.c
> index 081076771217..006a9a67c2a4 100644
> --- a/drivers/gpio/gpio-exar.c
> +++ b/drivers/gpio/gpio-exar.c
> @@ -124,9 +124,6 @@ static int gpio_exar_probe(struct platform_device *pdev)
>         void __iomem *p;
>         int index, ret;
>
> -       if (pcidev->vendor != PCI_VENDOR_ID_EXAR)
> -               return -ENODEV;
> -
>         /*
>          * Map the pci device to get the register addresses.
>          * We will need to read and write those registers to control
> diff --git a/drivers/tty/serial/8250/8250_exar.c b/drivers/tty/serial/8250/8250_exar.c
> index 8984e8b2d524..c29c7e675890 100644
> --- a/drivers/tty/serial/8250/8250_exar.c
> +++ b/drivers/tty/serial/8250/8250_exar.c
> @@ -245,7 +245,9 @@ pci_xr17v35x_setup(struct exar8250 *priv, struct pci_dev *pcidev,
>                 /* Setup Multipurpose Input/Output pins. */
>                 setup_gpio(pcidev, p);
>
> -               port->port.private_data = xr17v35x_register_gpio(pcidev);
> +               if (pcidev->vendor == PCI_VENDOR_ID_EXAR)
> +                       port->port.private_data =
> +                               xr17v35x_register_gpio(pcidev);
>         }
>
>         return 0;
> --
> 2.12.0
>



-- 
With Best Regards,
Andy Shevchenko