Re: [PATCH v2 3/3] arm64: dts: qcom: Specify dload address for msm8916 and msm8996

[Stephen Boyd]

On 05/26, Bjorn Andersson wrote:
> diff --git a/arch/arm64/boot/dts/qcom/msm8916.dtsi b/arch/arm64/boot/dts/qcom/msm8916.dtsi
> index ab3093995ded..33013835639d 100644
> --- a/arch/arm64/boot/dts/qcom/msm8916.dtsi
> +++ b/arch/arm64/boot/dts/qcom/msm8916.dtsi
> @@ -241,6 +241,8 @@
>  			clocks = <&gcc GCC_CRYPTO_CLK>, <&gcc GCC_CRYPTO_AXI_CLK>, <&gcc GCC_CRYPTO_AHB_CLK>;
>  			clock-names = "core", "bus", "iface";
>  			#reset-cells = <1>;
> +
> +			qcom,dload-mode-addr = <0x0 0x193d100>;

This is TCSR, so why not a phandle to a node?

>  		};
>  	};
>  
> diff --git a/arch/arm64/boot/dts/qcom/msm8996.dtsi b/arch/arm64/boot/dts/qcom/msm8996.dtsi
> index 9bc9c857a000..7e64884ab7c7 100644
> --- a/arch/arm64/boot/dts/qcom/msm8996.dtsi
> +++ b/arch/arm64/boot/dts/qcom/msm8996.dtsi
> @@ -261,6 +261,8 @@
>  	firmware {
>  		scm {
>  			compatible = "qcom,scm-msm8996";
> +
> +			qcom,dload-mode-addr = <0x0 0x7b3000>;

Also TCSR. Same question.

-- 
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project