On 05/30, Kiran Gunda wrote:Sure. will split it in to different patch or move it in the
From: Abhijeet Dharmapurikar <adharmap@xxxxxxxxxxxxxx>
irq_enable is called when the device resumes. Note that the
irq_enable is called regardless of whether the interrupt was
marked enabled/disabled in the descriptor or whether it was
masked/unmasked at the controller while resuming.
The current driver unconditionally clears the interrupt in its
irq_enable callback. This is dangerous as any interrupts that
happen right before the resume could be missed.
Remove the irq_enable callback and use mask/unmask instead.
Also remove struct pmic_arb_irq_spec as it serves no real purpose.
It is used only in the translate function and the code is much
cleaner without it.
Also a separate patch for that part....
Thanks !
Signed-off-by: Abhijeet Dharmapurikar <adharmap@xxxxxxxxxxxxxx>
Signed-off-by: Kiran Gunda <kgunda@xxxxxxxxxxxxxx>
---
drivers/spmi/spmi-pmic-arb.c | 29 +++--------------------------
1 file changed, 3 insertions(+), 26 deletions(-)
diff --git a/drivers/spmi/spmi-pmic-arb.c b/drivers/spmi/spmi-pmic-arb.c
index 0a5728c..bc03737 100644
--- a/drivers/spmi/spmi-pmic-arb.c
+++ b/drivers/spmi/spmi-pmic-arb.c
@@ -588,17 +588,6 @@ static void qpnpint_irq_unmask(struct irq_data *d)
qpnpint_spmi_write(d, QPNPINT_REG_EN_CLR, &data, 1);
}
-static void qpnpint_irq_enable(struct irq_data *d)
-{
- u8 irq = d->hwirq >> 8;
- u8 data;
-
- qpnpint_irq_unmask(d);
-
- data = BIT(irq);
- qpnpint_spmi_write(d, QPNPINT_REG_LATCHED_CLR, &data, 1);
-}
-
static int qpnpint_irq_set_type(struct irq_data *d, unsigned int flow_type)
{
struct spmi_pmic_arb_qpnpint_type type;
@@ -647,7 +636,6 @@ static int qpnpint_get_irqchip_state(struct irq_data *d,
static struct irq_chip pmic_arb_irqchip = {
.name = "pmic_arb",
- .irq_enable = qpnpint_irq_enable,
.irq_ack = qpnpint_irq_ack,
.irq_mask = qpnpint_irq_mask,
.irq_unmask = qpnpint_irq_unmask,
This looks ok.