Re: [PATCH v11 4/6] ARM: dts: imx6q-evi: support altera-ps-spi

[Andreas FÃrber]

Hi,

Am 25.05.2017 um 19:29 schrieb Joshua Clayton:
> Add support for Altera V FPGA connected to an spi port

Did you mean "Altera Cyclone V"?

> to the evi devicetree file
> 
> Signed-off-by: Joshua Clayton <stillcompiling@xxxxxxxxx>
> ---
>  arch/arm/boot/dts/imx6q-evi.dts | 16 ++++++++++++++++
>  1 file changed, 16 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/imx6q-evi.dts b/arch/arm/boot/dts/imx6q-evi.dts
> index 24fe093a66db..a0cbb2d84803 100644
> --- a/arch/arm/boot/dts/imx6q-evi.dts
> +++ b/arch/arm/boot/dts/imx6q-evi.dts
> @@ -82,6 +82,15 @@
>  	pinctrl-names = "default";
>  	pinctrl-0 = <&pinctrl_ecspi1 &pinctrl_ecspi1cs>;
>  	status = "okay";
> +
> +	fpga_spi: cyclonespi@0 {

"cyclonespi" does not strike me as the best node name.

I am guessing this is a sub-node of a SPI controller node, so no need to
repeat "spi", and Cyclone seems more or less implied by "altr,fpga-".

Note that the example in the bindings doc uses "evi-fpga-spi". Nodes
don't need to be (shouldn't be?) prefixed with the board. Note that
bindings examples tend to get copied a lot.

Any reason not to just use "fpga@0" in both places for simplicity?

> +		compatible = "altr,fpga-passive-serial";
> +		spi-max-frequency = <20000000>;
> +		reg = <0>;
> +		pinctrl-0 = <&pinctrl_fpgaspi>;
> +		nconfig-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>;
> +		nstat-gpios = <&gpio4 11 GPIO_ACTIVE_LOW>;
> +	};
>  };
>  
>  &ecspi3 {
[snip]

Regards,
Andreas

-- 
SUSE Linux GmbH, Maxfeldstr. 5, 90409 NÃrnberg, Germany
GF: Felix ImendÃrffer, Jane Smithard, Graham Norton
HRB 21284 (AG NÃrnberg)