Re: [PATCH NET V5 2/2] net: hns: Use phy_driver to setup Phy loopback

[Andrew Lunn]

> >> -		phy_write(phy_dev, COPPER_CONTROL_REG, val);
> >> +		err = phy_resume(phy_dev);
> > 
> > Maybe this was discussed with an earlier version of these patches. Why
> > are using phy_resume() and phy_suspend()?
> When self_test is invoked with ETH_TEST_FL_OFFLINE option, hns mac driver
> call dev_close to set net dev to offline state if net dev is online.
> Doing the actual phy loolback test require phy is power up, So phy_resume
> and phy_suspend are used.

O.K, so you at least need some comments, because this is not obvious.

>From your description, it sounds like you can call phy_resume() on a
device which is not suspended. In general, suspend is expected to
store away state which will be lost when powering down a
device. Resume writes that state back into the device after it is
powered up. So resuming a device which was never suspended could write
bad state into it.

Also, what about if WOL has been set before closing the device?

      Andrew