[PATCH v2 1/2] acpi: thermal: update thermal_zone after enable the driver.

[Enric Balletbo i Serra]

Use thermal_set_mode instead of just set the tz_enable variable when
enabling the ACPI thermal driver. The purpose of this change is trigger
a thermal_zone_device_update when driver switches from disabled to
enabled mode so thermal_zone data is up-to-date.

Signed-off-by: Enric Balletbo i Serra <enric.balletbo@xxxxxxxxxxxxx>
---
This patch is new from v1 [1]

[1] https://patchwork.kernel.org/patch/9804229/

 drivers/acpi/thermal.c | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/drivers/acpi/thermal.c b/drivers/acpi/thermal.c
index 1d0417b..9949458 100644
--- a/drivers/acpi/thermal.c
+++ b/drivers/acpi/thermal.c
@@ -930,7 +930,9 @@ static int acpi_thermal_register_thermal_zone(struct acpi_thermal *tz)
 	if (ACPI_FAILURE(status))
 		return -ENODEV;
 
-	tz->tz_enabled = 1;
+	result = thermal_set_mode(tz->thermal_zone, THERMAL_DEVICE_ENABLED);
+	if (result)
+		return result;
 
 	dev_info(&tz->device->dev, "registered as thermal_zone%d\n",
 		 tz->thermal_zone->id);
-- 
2.9.3