Currently the compatible âqcom,nandcsâ is being used for each
connected NAND device to support for multiple NAND devices in the
same bus. The same thing can be achieved by looking reg property
for each sub nodes which contains the chip select number so this
patch removes the use of âqcom,nandcsâ for specifying NAND device
sub nodes.
Since there is no user for this driver currently in so
changing compatible string is safe.
Signed-off-by: Abhishek Sahu <absahu@xxxxxxxxxxxxxx>
---
drivers/mtd/nand/qcom_nandc.c | 26 ++++++++++++--------------
1 file changed, 12 insertions(+), 14 deletions(-)
diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
index 8fa2f0c..110a26a 100644
--- a/drivers/mtd/nand/qcom_nandc.c
+++ b/drivers/mtd/nand/qcom_nandc.c
@@ -2129,22 +2129,20 @@ static int qcom_nandc_probe(struct platform_device *pdev)
goto err_setup;
for_each_available_child_of_node(dn, child) {
- if (of_device_is_compatible(child, "qcom,nandcs")) {
- host = devm_kzalloc(dev, sizeof(*host), GFP_KERNEL);
- if (!host) {
- of_node_put(child);
- ret = -ENOMEM;
- goto err_cs_init;
- }
-
- ret = qcom_nand_host_init(nandc, host, child);
- if (ret) {
- devm_kfree(dev, host);
- continue;
- }
+ host = devm_kzalloc(dev, sizeof(*host), GFP_KERNEL);
+ if (!host) {
+ of_node_put(child);
+ ret = -ENOMEM;
+ goto err_cs_init;
+ }
- list_add_tail(&host->node, &nandc->host_list);
+ ret = qcom_nand_host_init(nandc, host, child);
+ if (ret) {
+ devm_kfree(dev, host);
+ continue;
}
+
+ list_add_tail(&host->node, &nandc->host_list);
}
if (list_empty(&nandc->host_list)) {