Re: [PATCH 5/5] Documentation: bindings: Add ti,lmp92001

From: Linus Walleij
Date: Mon Aug 07 2017 - 05:23:50 EST


On Tue, Aug 1, 2017 at 11:17 AM, <s.abhisit@xxxxxxxxx> wrote:


> + - #gpio-cells : Should be two. The first cell is the pin number and the
> + second cell is used to specify the gpio polarity:
> + 0 = Active high
> + 1 = Active low

Just reference the standard bindings?

> +- ti,lmp92001-gpio-dir: bit mask for direction and drive logic default. Since
> + the direction and the internal pull-down are shared register and similar to
> + open-collector drive:
> + 0 = [O]utput and also meaning drive it to low
> + 1 = [I]nput and also meaning open, to drive it to high is required to
> + have an external resistor

NACK this is totally wrong.

When using GPIO descriptors, consumers specify open drain/collector, not
producers. The same applies to this: the consumers should specify it not
the producer.

You need to either add a pin control interface/driver or extend the GPIO
bindings for consumers to do this, I thin pin control is the right thing here.
It's gonna be complicated but much better.

Yours,
Linus Walleij