Re: [PATCH v6 0/2] Add basic support for Mediatek MT2712 SoC

[Matthias Brugger]

On 08/04/2017 01:59 PM, YT Shen wrote:
> MT2712 is a SoC based on 64bit ARMv8 architecture.
> MT2712 share many HW IP with MT8173.  This patchset was tested on MT2712 evaluation board, and boot to shell ok.
>
> This series contains document bindings, device tree including interrupt and uart.

pushed to v4.13-next/dts64

Thanks

> Changes compared to v5:
> - remove the soc node
>
> Changes compared to v4:
> - rebase to 4.13-rc1
> - use two clocks (baud_clk & sys_clk) instead of one uart_clk to the correct bindings
>
> Changes compared to v3:
> - use two uart clocks refer to the bindings
>
> Changes compared to v2:
> - remove alias from serial1 to serial5
> - remove initrd-start and initrd-end
> - change GIC_CPU_MASK_SIMPLE(6) to GIC_CPU_MASK_RAW(0x13)
> - change gic-400 reg range
>
> Changes compared to v1:
> - change subject prefix for bindings
> - change device tree license to SPDX tag.
> - change bootargs parameter to DT usage.
> - change intpol-controller to interrupt-controller
>
> YT Shen (2):
>    dt-bindings: arm: Add bindings for Mediatek MT2712 SoC Platform
>    arm64: dts: Add Mediatek SoC MT2712 and evaluation board dts and
>      Makefile
>
>   Documentation/devicetree/bindings/arm/mediatek.txt |   4 +
>   .../interrupt-controller/mediatek,sysirq.txt       |   1 +
>   .../devicetree/bindings/serial/mtk-uart.txt        |   1 +
>   arch/arm64/boot/dts/mediatek/Makefile              |   1 +
>   arch/arm64/boot/dts/mediatek/mt2712-evb.dts        |  32 ++++
>   arch/arm64/boot/dts/mediatek/mt2712e.dtsi          | 171 +++++++++++++++++++++
>   6 files changed, 210 insertions(+)
>   create mode 100644 arch/arm64/boot/dts/mediatek/mt2712-evb.dts
>   create mode 100644 arch/arm64/boot/dts/mediatek/mt2712e.dtsi