Re: [PATCH net v2 2/2] net: ixgbe: Use new PCI_DEV_FLAGS_NO_RELAXED_ORDERING flag

[Ding Tianhong]

On 2017/8/18 13:04, Tantilov, Emil S wrote:
>> -----Original Message-----
>> From: Ding Tianhong [mailto:dingtianhong@xxxxxxxxxx]
>> Sent: Thursday, August 17, 2017 5:39 PM
>> To: Tantilov, Emil S <emil.s.tantilov@xxxxxxxxx>; davem@xxxxxxxxxxxxx;
>> Kirsher, Jeffrey T <jeffrey.t.kirsher@xxxxxxxxx>; keescook@xxxxxxxxxxxx;
>> linux-kernel@xxxxxxxxxxxxxxx; sparclinux@xxxxxxxxxxxxxxx; intel-wired-
>> lan@xxxxxxxxxxxxxxxx; alexander.duyck@xxxxxxxxx; netdev@xxxxxxxxxxxxxxx;
>> linuxarm@xxxxxxxxxx
>> Subject: Re: [PATCH net v2 2/2] net: ixgbe: Use new
>> PCI_DEV_FLAGS_NO_RELAXED_ORDERING flag
>>
>>
>>
>> On 2017/8/17 22:17, Tantilov, Emil S wrote:
>>
>>>> 	ret_val = ixgbe_start_hw_generic(hw);
>>>>
>>>> -#ifndef CONFIG_SPARC
>>>> -	/* Disable relaxed ordering */
>>>> -	for (i = 0; ((i < hw->mac.max_tx_queues) &&
>>>> -	     (i < IXGBE_DCA_MAX_QUEUES_82598)); i++) {
>>>> -		regval = IXGBE_READ_REG(hw, IXGBE_DCA_TXCTRL(i));
>>>> -		regval &= ~IXGBE_DCA_TXCTRL_DESC_WRO_EN;
>>>> -		IXGBE_WRITE_REG(hw, IXGBE_DCA_TXCTRL(i), regval);
>>>> -	}
>>>> +	if (!pcie_relaxed_ordering_enabled(adapter->pdev)) {
>>>
>>> As Alex mentioned there is no need for this check in any form.
>>>
>>> The HW defaults to Relaxed Ordering enabled unless it is disabled in
>>> the PCIe Device Control Register. So the above logic is already done by
>> HW.
>>>
>>> All you have to do is strip the code disabling relaxed ordering.
>>>
>>
>> Hi Tantilov:
>>
>> I misunderstood Alex's suggestion, But I still couldn't find the logic
>> where
>> the HW disable the Relaxed Ordering when the PCIe Device Control Register
>> disable it, can you point it out?
> 
> If you look at the datasheet (82599) - the description of CTRL_EXT.RO_DIS (bit 17, 0b):
> 
> Relaxed Ordering Disable. When set to 1b, the device does not request any relaxed
> ordering transactions. When this bit is cleared and the Enable Relaxed Ordering bit in
> the Device Control register is set, the device requests relaxed ordering transactions per queues as configured in the DCA_RXCTRL[n] and DCA_TXCTRL[n] registers.
> 
> So if you remove the code that clears the bits in DCA_T/RXCTRL relaxed ordering should
> be enabled by HW when the bus allows it.
> 

Great, Thanks for your explanation.

> Thanks,
> Emil
> 
> 
> .
>