RE: [PATCH v5 0/3] TPS68470 PMIC drivers

[Mani, Rajmohan]

Hi Andy,

> > >> > This is the patch series for TPS68470 PMIC that works as a camera PMIC.
> > >> >
> > >> > The patch series provide the following 3 drivers, to help configure the
> voltage regulators, clocks and GPIOs provided by the TPS68470 PMIC, to be
> able to use the camera sensors connected to this PMIC.
> > >> >
> > >> > TPS68470 MFD driver:
> > >> > This is the multi function driver that initializes the TPS68470 PMIC and
> supports the GPIO and Op Region functions.
> > >> >
> > >> > TPS68470 GPIO driver:
> > >> > This is the PMIC GPIO driver that will be used by the OS GPIO layer,
> when the BIOS / firmware triggered GPIO access is done.
> > >> >
> > >> > TPS68470 Op Region driver:
> > >> > This is the driver that will be invoked, when the BIOS / firmware
> configures the voltage / clock for the sensors / vcm devices connected to the
> PMIC.
> > >> >
> > >>
> > >> All three patches are good to me (we did few rounds of internal
> > >> review before posting v4)
> > >>
> > >> Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx>
> > >
> > > OK, so how should they be routed?
> >
> > Good question. I don't know how last time PMIC drivers were merged,
> > here I think is just sane to route vi MFD with immutable branch
> > created.
> 
> OK
> 
> I will assume that the series will go in through MFD then.
> 

Now that the MFD and GPIO patches of v6 of this series have been applied on respective trees, can you advise the next steps for the ACPI / PMIC Opregion driver?

Thanks
Raj