Re: [PATCH v2 00/16] mmc: meson-gx: driver fixups and upgrades

[Ulf Hansson]

On 21 August 2017 at 18:02, Jerome Brunet <jbrunet@xxxxxxxxxxxx> wrote:
> The patchset features several bugfixes, rework and upgrade for the
> meson-gx MMC driver.
>
> The main goal is to improve readability and enable new high speed
> modes, such as eMMC DDR52 and sdcard UHS modes up to SDR50 (100Mhz)
>
> SDR104 is not working with a few cards on the p200 and the
> libretech-cc. I suspect that 200Mhz might be a bit too fast for the PCB
> of these boards, adding noise to the signal and eventually breaking
> the communication with some cards. The same cards are working well on a
> laptop or the nanopi-k2 at 200Mhz.
>
> This series has been tested on gxbb-p200, gxbb-nanopi-k2 and
> gxl-s905x-libretech-cc
>
> Changes since v1 [0]:
> * Reorder patches to have fixes first, then rework and finally
>   enhancements.
> * Use CCF to manage clock phases
>
> [0]: https://lkml.kernel.org/r/20170804174353.16486-1-jbrunet@xxxxxxxxxxxx
>
> Jerome Brunet (16):
>   mmc: meson-gx: fix mux mask definition
>   mmc: meson-gx: remove CLK_DIVIDER_ALLOW_ZERO clock flag
>   mmc: meson-gx: clean up some constants
>   mmc: meson-gx: use _irqsave variant of spinlock
>   mmc: meson-gx: cfg init overwrite values
>   mmc: meson-gx: rework set_ios function
>   mmc: meson-gx: rework clk_set function
>   mmc: meson-gx: rework clock init function
>   mmc: meson-gx: fix dual data rate mode frequencies
>   mmc: meson-gx: work around clk-stop issue
>   mmc: meson-gx: simplify interrupt handler
>   mmc: meson-gx: implement card_busy callback
>   mmc: meson-gx: use CCF to handle the clock phases
>   mmc: meson-gx: implement voltage switch callback
>   mmc: meson-gx: change default tx phase
>   mmc: meson-gx: rework tuning function
>
>  drivers/mmc/host/meson-gx-mmc.c | 718 +++++++++++++++++++++++++++-------------
>  1 file changed, 497 insertions(+), 221 deletions(-)
>
> --
> 2.9.5
>

So far, I decided to pick patch 1 -> 3.

Kind regards
Uffe