Re: [PATCH v2 1/2] net: stmmac: Delete dead code for MDIO registration

[Romain Perier]

Hello,


Le 22/08/2017 Ã 02:45, Florian Fainelli a Ãcrit :
> On 08/21/2017 04:45 AM, Romain Perier wrote:
>> This code is no longer used, the logging function was changed by commit
>> fbca164776e4 ("net: stmmac: Use the right logging functi").
>>
>> Fixes: fbca164776e4 ("net: stmmac: Use the right logging functi")
>> Signed-off-by: Romain Perier <romain.perier@xxxxxxxxxxxxx>
>> ---
>>  drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c | 16 ----------------
>>  1 file changed, 16 deletions(-)
>>
>> diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
>> index 72ec711fcba2..f5f37bfa1d58 100644
>> --- a/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
>> +++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_mdio.c
>> @@ -248,9 +248,6 @@ int stmmac_mdio_register(struct net_device *ndev)
>>  	found = 0;
>>  	for (addr = 0; addr < PHY_MAX_ADDR; addr++) {
>>  		struct phy_device *phydev = mdiobus_get_phy(new_bus, addr);
>> -		int act = 0;
>> -		char irq_num[4];
>> -		char *irq_str;
>>  
>>  		if (!phydev)
>>  			continue;
>> @@ -273,19 +270,6 @@ int stmmac_mdio_register(struct net_device *ndev)
>>  		if (priv->plat->phy_addr == -1)
>>  			priv->plat->phy_addr = addr;
>>  
>> -		act = (priv->plat->phy_addr == addr);
>> -		switch (phydev->irq) {
>> -		case PHY_POLL:
>> -			irq_str = "POLL";
>> -			break;
>> -		case PHY_IGNORE_INTERRUPT:
>> -			irq_str = "IGNORE";
>> -			break;
>> -		default:
>> -			sprintf(irq_num, "%d", phydev->irq);
>> -			irq_str = irq_num;
>> -			break;
>> -		}
> I was actually just looking into moving these prints to
> phy_attached_info(), since it is useful to know whether the interrupt is
> POLL, IGNORE, or valid. Can you move that there? Then you can really
> migrate over phy_attached_info() with no information loss.
>
> Thanks!
Sure, I can take a look.

Thanks,
Romain