Re: [PATCH] mfd: Add support for TI LMP92001

[Lee Jones]

On Tue, 22 Aug 2017, Abhisit Sangjan wrote:

> Hi Jonathan - Thank you for your review, I will clean up and submit again.

Please do not top post, only reply in-line.

Also, when replying to a mail, especially one of this length, please
snip past your last comment.  Some people complain that it's a waste
of data (which I don't really subscribe to TBH), but it certainly is a
waste of people's time.  I just spent a good amount of time scrolling
through your reply looking for a response to Jonathan's review, but
none was found.

> On Tue, Aug 22, 2017 at 9:03 PM, Jonathan Cameron <
> Jonathan.Cameron@xxxxxxxxxx> wrote:
> 
> > On Tue, 22 Aug 2017 13:26:11 +0700
> > <s.abhisit@xxxxxxxxx> wrote:
> >
> > > From: Abhisit Sangjan <s.abhisit@xxxxxxxxx>
> > >
> > > TI LMP92001 Analog System Monitor and Controller
> > >
> > > 8-bit GPIOs.
> > > 12 DACs with 12-bit resolution.
> > > The GPIOs and DACs are shared port function with Cy function pin to
> > > take control the pin suddenly from external hardware.
> > > DAC's referance voltage selectable for Internal/External.
> > >
> > > 16 + 1 ADCs with 12-bit resolution.
> > > Built-in internal Temperature Sensor on channel 17.
> > > Windows Comparator Function is supported on channel 1-3 and 9-11 for
> > > monitoring with interrupt signal (pending to implement for interrupt).
> > > ADC's referance voltage selectable for Internal/External.
> > >
> > > Signed-off-by: Abhisit Sangjan <s.abhisit@xxxxxxxxx>
> >
> > As Lee said, break this up.  I've done a quick read through but much easier
> > to parse in smaller parts!

-- 
Lee Jones
Linaro STMicroelectronics Landing Team Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog