Re: [EXT] Re: [PATCH net-next 09/13] net: mvpp2: dynamic reconfiguration of the PHY mode

From: Russell King - ARM Linux
Date: Fri Aug 25 2017 - 04:20:28 EST


On Thu, Aug 24, 2017 at 07:14:18PM +0200, Antoine Tenart wrote:
> On Thu, Aug 24, 2017 at 05:08:29PM +0000, Stefan Chulski wrote:
> > > > Imagine phylib is using the copper Ethernet PHY, but the MAC is using
> > > > the SFP port. Somebody pulls out the copper cable, phylib says the
> > > > link is down, turns the carrier off and calls the callback. Not good,
> > > > since your SFP cable is still plugged in... Ethtool is
> > > > returning/setting stuff in the Copper Ethernet PHY, when in fact you
> > > > intend to be setting SFP settings.
> > >
> > > I see what could be the issue but I do not understand one aspect though:
> > > how could we switch from one PHY to another, as there's only one output
> > > between the SoC (and so a given GoP#) and the board. So if a given PHY can
> > > handle multiple modes I see, but in the other case a muxing somewhere would
> > > be needed? Or did I miss something?
> >
> > I think PHY name and PHY mode struct that describe here both MAC to
> > PHY and PHY to PHY connection create confusion... Serdes IP lane
> > doesn't care if connector is SFP, RJ45 or direct attached cable.
> > mvpp22_comphy_init only configures MAC to PHY
> > connection. SFI for 10G(KR in mainline), SGMII for 1G and HS_SGMII for
> > 2.5G.
>
> So maybe one confusion was to name them PHY_MODE_10GKR and
> PHY_MODE_SGMII. It could be PHY_MODE_10G and PHY_MODE_1G instead.

SGMII mode supports 100M and 10M as well using data repetition, so 1G
makes it look like those speeds are not supported.

--
RMK's Patch system: http://www.armlinux.org.uk/developer/patches/
FTTC broadband for 0.8mile line in suburbia: sync at 8.8Mbps down 630kbps up
According to speedtest.net: 8.21Mbps down 510kbps up