Re: [RFC 3/4] mmc: sdhci-msm: Change the desc_sz on cqe_enable/disable.

From: Ritesh Harjani
Date: Sat Sep 02 2017 - 01:12:49 EST




On 8/31/2017 12:12 PM, Adrian Hunter wrote:
On 30/08/17 16:04, Ritesh Harjani wrote:
When CMDQ is halted the HW expects descriptor size to
be same which is using in CMDQ mode.
Thus adjust the desc_sz of sdhci accordingly.

Without this patch below command gives ADMA error
when CQE is enabled.
cat /sys/kernel/debug/mmc0/mmc0:0001/ext_csd

Signed-off-by: Ritesh Harjani <riteshh@xxxxxxxxxxxxxx>
---
drivers/mmc/host/sdhci-msm.c | 24 ++++++++++++++++++++++--
1 file changed, 22 insertions(+), 2 deletions(-)

diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
index 346cdfb..baa3409 100644
--- a/drivers/mmc/host/sdhci-msm.c
+++ b/drivers/mmc/host/sdhci-msm.c
@@ -1111,9 +1111,29 @@ static u32 sdhci_msm_cqe_irq(struct sdhci_host *host, u32 intmask)
return 0;
}
+void sdhci_msm_cqe_enable(struct mmc_host *mmc)
+{
+ struct sdhci_host *host = mmc_priv(mmc);
+
+ if (host->flags & SDHCI_USE_64_BIT_DMA)
+ host->desc_sz = 12;

This has no effect.

Yes, I added it for the sake of completion.
Sure I will check on this.


+
+ sdhci_cqe_enable(mmc);
+}
+
+void sdhci_msm_cqe_disable(struct mmc_host *mmc, bool recovery)
+{
+ struct sdhci_host *host = mmc_priv(mmc);
+
+ if (host->flags & SDHCI_USE_64_BIT_DMA)
+ host->desc_sz = 16;

You can't change the descriptor size this way. If you need 128-bit ADMA
descriptors it must be done in sdhci_setup_host().

Let me again check on this once. I will get back then.
Thanks.


+
+ sdhci_cqe_disable(mmc, recovery);
+}
+
static const struct cqhci_host_ops sdhci_msm_cqhci_ops = {
- .enable = sdhci_cqe_enable,
- .disable = sdhci_cqe_disable,
+ .enable = sdhci_msm_cqe_enable,
+ .disable = sdhci_msm_cqe_disable,
};
#ifdef CONFIG_MMC_CQHCI



--
Qualcomm India Private Limited, on behalf of Qualcomm Innovation Center, Inc.
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project.