Re: [PATCH] pps-gpio: use IRQ edge config when not capturing both edges

[Rodolfo Giometti]

On 08/09/2017 21:53, Tim Harvey wrote:
> PPS signals with very short pulse-widths can be missed if their state
> changes by the time the interrupt handler reads the GPIO pin state.
>
> To avoid this in the case where we are only looking for one edge we can
> use the edge configuration for the pin state but fall back to reading the
> pin if both edges are being watched.

I disagree. The "rising_edge" status should be get from the hardware and not 
derived by an empirical computation. Or, at least, it should be specifically 
activated by setting something like this:

        pps {
                pinctrl-names = "default";
                pinctrl-0 = <&pinctrl_pps>;

                gpios = <&gpio1 26 GPIO_ACTIVE_HIGH>;
		Yes-I-want-get-signal-status-in-an-epirical-way;

                compatible = "pps-gpio";
                status = "okay";
        };

This setting should also print a warning in order to be clear for the user that 
he/she should know what he/she is doing.

Then the code should check also the compatibility with property 
"assert-falling-edge"...

Ciao,

Rodolfo

--

HCE Engineering                      e-mail: giometti@xxxxxxxxxxxxxxxxxx
GNU/Linux Solutions                          giometti@xxxxxxxxxxxx
Linux Device Driver                          giometti@xxxxxxxx
Embedded Systems                     phone:  +39 349 2432127
UNIX programming                     skype:  rodolfo.giometti
Cosino Project - the quick prototyping embedded system - www.cosino.it
Freelance ICT Italia - Consulente ICT Italia - www.consulenti-ict.it