[PATCH v2 0/3] Altera ASMI Parallel II IP Core

[matthew . gerlach]

From: Matthew Gerlach <matthew.gerlach@xxxxxxxxxxxxxxx>

This patch set adds a spi-nor flash driver for the Altera ASMI Parallel II 
IP Core.  This driver was created based on feedback from Marek Vasut,
Cyrill Pitchen, and Michal Suchanek regarding Version 2 of the Altera
Quadspi Controller: https://lkml.org/lkml/2017/6/26/518

The overall problem with Version 2 of the Altera Quadspi Controller and 
its driver was the fact that there was much duplication of code and logic
with the spi-nor framework.  This new combination of fpga hardware and 
software "gets out of the way" of the spi-nor framework.  The result is a
much simpler driver with the spi-nor framework performing the bulk of the work.

Patch 1 contains the device tree bindings for the driver for
the Altera ASMI-Parallel II IP Core.

Patch 2 contains the driver code for the Altera ASMI-Parallel II IP Core.
This driver supports being configured via a device tree or with platform
data.  In the later case, the memory for the registers has been remapped.

Patch 3 contains a work around for some non-standard behavior of EPCQ flash.

Matthew Gerlach (3):
  dt-bindings: mtd: Altera ASMI Parallel II IP Core
  mtd: spi-nor: Altera ASMI Parallel II IP Core
  mtd: spi-nor: add flag for reading dummy cycles from nv cfg reg

 .../devicetree/bindings/mtd/altera-asmip2.txt      |  15 +
 MAINTAINERS                                        |   7 +
 drivers/mtd/spi-nor/Kconfig                        |   6 +
 drivers/mtd/spi-nor/Makefile                       |   1 +
 drivers/mtd/spi-nor/altera-asmip2.c                | 478 +++++++++++++++++++++
 include/linux/mtd/altera-asmip2.h                  |  27 ++
 6 files changed, 534 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/mtd/altera-asmip2.txt
 create mode 100644 drivers/mtd/spi-nor/altera-asmip2.c
 create mode 100644 include/linux/mtd/altera-asmip2.h

-- 
2.7.4