Re: [PATCH 0/2] kprobes: improve error handling when arming/disarming kprobes

[Steven Rostedt]

Masami,

Can you review these patches?

-- Steve


On Wed,  4 Oct 2017 21:14:12 +0200
Jessica Yu <jeyu@xxxxxxxxxx> wrote:

> Hi,
> 
> This patchset attempts to improve error handling when arming or disarming
> ftrace-based kprobes. The current behavior is to simply WARN when ftrace
> (un-)registration fails, without propagating the error code. This can lead
> to confusing situations where, for example, register_kprobe()/enable_kprobe()
> would return 0 indicating success even if arming via ftrace had failed. In
> this scenario we'd end up with a non-functioning kprobe even though kprobe
> registration (or enablement) returned success. In this patchset, we take
> errors from ftrace into account and propagate the error when we cannot arm
> or disarm a kprobe.
> 
> Below is an example that illustrates the problem using livepatch and
> systemtap (which uses kprobes underneath). Both livepatch and kprobes use
> ftrace ops with the IPMODIFY flag set, so registration at the same
> function entry is limited to only one ftrace user. 
> 
> Before
> ------
> # modprobe livepatch-sample 	# patches cmdline_proc_show, ftrace ops has IPMODIFY set
> # stap -e 'probe kernel.function("cmdline_proc_show").call { printf ("cmdline_proc_show\n"); }'
> 
>    .. (nothing prints after reading /proc/cmdline) ..
> 
> The systemtap handler doesn't execute due to a kprobe arming failure caused
> by a ftrace IPMODIFY conflict with livepatch, and there isn't an obvious
> indication of error from systemtap (because register_kprobe() returned
> success) unless the user inspects dmesg.
> 
> After
> -----
> # modprobe livepatch-sample 
> # stap -e 'probe kernel.function("cmdline_proc_show").call { printf ("cmdline_proc_show\n"); }'
> WARNING: probe kernel.function("cmdline_proc_show@/home/jeyu/work/linux-next/fs/proc/cmdline.c:6").call (address 0xffffffffa82fe910) registration error (rc -16)
> 
> Although the systemtap handler doesn't execute (as it shouldn't), the
> ftrace error is propagated and now systemtap prints a visible error message
> stating that (kprobe) registration had failed (because register_kprobe()
> returned an error), along with the propagated error code.
> 
> This patchset was based on Petr Mladek's original patchset (patches 2 and 3)
> back in 2015, which improved kprobes error handling, found here:
> 
>    https://lkml.org/lkml/2015/2/26/452
> 
> However, further work on this had been paused since then and the patches
> were not upstreamed.
> 
> This patchset has been lightly sanity-tested (on linux-next) with kprobes,
> kretprobes, jprobes, and optimized kprobes. It passes the kprobes smoke
> test, but more testing is greatly appreciated.
> 
> Thanks,
> 
> Jessica
> 
> ---
> Jessica Yu (2):
>   kprobes: propagate error from arm_kprobe_ftrace()
>   kprobes: propagate error from disarm_kprobe_ftrace()
> 
>  kernel/kprobes.c | 163 ++++++++++++++++++++++++++++++++++++++-----------------
>  1 file changed, 112 insertions(+), 51 deletions(-)
>