Re: about pca955x led driver gpio management

[Andrea Scian - DAVE Embedded Systems]

Il 17/10/2017 10:18, Cédric Le Goater ha scritto:
> On 10/17/2017 09:36 AM, Andrea Scian - DAVE Embedded Systems wrote:
> > Dear all,
> >
> > I'm working on an iMX6 based board with a PCA9555 which is used both to drive LEDs and manage some GPIOs.
> The PCA9555 chip and the PCA955[0-3] chips have different control
> registers. You need a different led driver for it.

My typo sorry, as you can see in the device tree below, I'm using pca9551

> > My current kernel is quite old (4.1.15) but I've found Cédric patches on mainline and backported to this old revision.
> >
> > I'm facing an issue with it, because it seems that it fails when it's used in a mixed (led/gpios) environment.
> >
> > E.g.: let's say that I have one led connected to LED0 output and one GPIO connected at LED1 output.
> >
> > I define it as
> >
> >                          pca9551: pca9551@60 {
> >                                  compatible = "nxp,pca9551";
> >                                  reg = <0x60>;
> >                                  #address-cells = <1>;
> >                                  #size-cells = <0>;
> >                                  #gpio-cells = <1>;
> >
> >                                  led@0 {
> >                                          label = "led0";
> >                                          reg = <0>;
> >                                          linux,default-trigger = "none";
> >                                  };
> >                                  gpio@1 {
> >                                          label = "gpio1";
> >                                          reg = <1>;
> >                                          type = <2>; /* GPIO */
> >                                  };
> >                  };
> >
> > At boot it's probed as
> >
> > root@sbc-lynx:~# dmesg | grep pca
> > [    5.315425] leds-pca955x 5-0060: leds-pca955x: Using pca9551 8-bit LED driver at slave address 0x60
> > [    5.350349] leds-pca955x 5-0060: gpios 511...511
> >
> > But I cannot access it:
> >
> > root@sbc-lynx:~# echo 511 > /sys/class/gpio/export
> > -sh: echo: write error: Device or resource busy
> >
> > Because for pca955x_gpio_request_pin() this is at offset 0 (in fact is the first gpio registered of this gpio_chip) but it's the index 1 inside pca955x->leds[]
> >
> > Am I missing something? (maybe I made a mistake in my backport and/or I'm missing some patches about the GPIO subsystems).
> >
> > If I'm right I think I can send a patch to fix this (I'm thinking about having an array of GPIO index to map offset -> pca955x->leds[] index or just register all pins as GPIOs and then just report the busy state)
> >
> > WDYT?
> >
> > Kind Regards,