[PATCH] usb: dwc2: host: Setting TOUTCAL and USBTRDTIM fields in host mode

[Minas Harutyunyan]

Added missing GUSBCFG programming in host mode.

These fields even if was programmed in device mode (in function
dwc2_hsotg_core_init_disconnected()) will be resetting to POR values
after core soft reset applied.
So, each time when switching to host mode required to set these fields
to correct values. It's allow fix issues with lot of transaction errors
due to timeouts and turnarrounds on USB bus.

Signed-off-by: Minas Harutyunyan <hminas@xxxxxxxxxxxx>
---
 drivers/usb/dwc2/hcd.c | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/drivers/usb/dwc2/hcd.c b/drivers/usb/dwc2/hcd.c
index f4ef159b538e..1f65464055b9 100644
--- a/drivers/usb/dwc2/hcd.c
+++ b/drivers/usb/dwc2/hcd.c
@@ -2311,10 +2311,17 @@ static int dwc2_core_init(struct dwc2_hsotg *hsotg, bool initial_setup)
  */
 static void dwc2_core_host_init(struct dwc2_hsotg *hsotg)
 {
-	u32 hcfg, hfir, otgctl;
+	u32 hcfg, hfir, otgctl, usbcfg, val;
 
 	dev_dbg(hsotg->dev, "%s(%p)\n", __func__, hsotg);
 
+	/* Set HS/FS Timeout Calibration and USBTrdTim */
+	usbcfg = dwc2_readl(hsotg->regs + GUSBCFG);
+	usbcfg &= ~(GUSBCFG_TOUTCAL_MASK | GUSBCFG_USBTRDTIM_MASK);
+	val = (hsotg->phyif == GUSBCFG_PHYIF8) ? 9 : 5;
+	usbcfg |= (GUSBCFG_TOUTCAL(7) | (val << GUSBCFG_USBTRDTIM_SHIFT));
+	dwc2_writel(usbcfg, hsotg->regs + GUSBCFG);
+
 	/* Restart the Phy Clock */
 	dwc2_writel(0, hsotg->regs + PCGCTL);
 
-- 
2.11.0