Re: [PATCH v4 0/4] fix the clock setting for SAR ADC

[Martin Blumenstingl]

Hi Yixun,

On Tue, Nov 7, 2017 at 10:36 PM, Martin Blumenstingl
<martin.blumenstingl@xxxxxxxxxxxxxx> wrote:
> Hi Yixun,
>
> On Tue, Nov 7, 2017 at 3:09 PM, Yixun Lan <yixun.lan@xxxxxxxxxxx> wrote:
>> patch [1/4]:
>>   Fix wrong SARADC/SANA clock gate bit in Meson-GXBB/GXL,
>> the published datasheets[4] also has wrong description about this.
>>   This patch should be explicitly merged *before* other patches.
>>
>> patch [2-4/4]:
>>   Drop the "sana" clock from SAR ADC module,
> I agree with Jerome that patch 2/4 should be applied last.
> when I wrote the driver I couldn't get it to work on my GXBB board
> (which unfortunately has died since then) because the clocks were
> disabled (they weren't enabled by the bootloader). people who are
> using an old .dtb would get the same problem again until the clock
> driver is merged
>
>>   From the hardware perspective, the SAR ADC module doesn't
>> require "sana" clock to wrok. This should apply to all SoC,
>> including meson6,8, GXBB, GXL..
> thank you for clarifying this!
>
>> Note: the whole patchset series has been tested at GXL-P212 board,
>> we haven't got any meson6,8 board to test, so I would appreciate
>> if someone (Martin?) could help to confirm it works there.
> I can test this on a Meson8b and a Meson8m2 board on the weekend -
> I'll let you know about the results
the ADC still works fine with this series applied on my Meson8m2 board
as well as my Meson8b EC-100
I added my "Reviewed-by" and "Acked-by" to the corresponding patches
(with a change request on the .dts patch)

Thank you for fixing this!


Regards
Martin