[PATCH net-next v5 0/2] add UniPhier AVE ethernet support

From: Kunihiko Hayashi
Date: Mon Dec 11 2017 - 02:57:50 EST


This series adds support for Socionext AVE ethernet controller implemented
on UniPhier SoCs. This driver supports RGMII/RMII modes.

v4: https://www.spinics.net/lists/netdev/msg469294.html

The PHY patch included in v1 has already separated in:
http://www.spinics.net/lists/netdev/msg454595.html

Changes since v4:
- fix larger integer warning on AVE_PFMBYTE_MASK0

Changes since v3:
- remove checking dma address and use dma_set_mask() to restirct address
- replace ave_mdio_busywait() with read_poll_timeout()
- replace functions to access to registers with readl/writel() directly
- replace a function to access to macaddr with ave_hw_write_macaddr()
- change return value of ave_dma_map() to error value
- move mdiobus_unregister() from ave_remove() to ave_uninit()
- eliminate else block at the end of ave_dma_map()
- add mask definitions for packet filter
- sort bitmap definitions in descending order
- add error check to some functions
- rename and sort functions to clear sub-categories
- fix error value consistency
- remove unneeded initializers
- change type of constant arrays

Changes since v2:
- replace clk_get() with devm_clk_get()
- replace reset_control_get() with devm_reset_control_get_optional_shared()
- add error return when the error occurs on the above *_get functions
- sort soc data and compatible strings
- remove clearly obvious comments
- modify dt-bindings document consistent with these modifications

Changes since v1:
- add/remove devicetree properties and sub-node
- remove "internal-phy-interrupt" and "desc-bits" property
- add SoC data structures based on compatible strings
- add node operation to apply "mdio" sub-node
- add support for features
- add support for {get,set}_pauseparam and pause frame operations
- add support for ndo_get_stats64 instead of ndo_get_stats
- replace with desiable functions
- replace check for valid phy_mode with phy_interface{_mode}_is_rgmii()
- replace phy attach message with phy_attached_info()
- replace 32bit operation with {upper,lower}_32_bits() on ave_wdesc_addr()
- replace nway_reset and get_link with generic functions
- move operations to proper functions
- move phy_start_aneg() to ndo_open,
and remove unnecessary PHY interrupt operations
See http://www.spinics.net/lists/netdev/msg454590.html
- move irq initialization and descriptor memory allocation to ndo_open
- move initialization of reset and clock and mdiobus to ndo_init
- fix skbuffer operations
- fix skb alignment operations and add Rx buffer adjustment for descriptor
See http://www.spinics.net/lists/netdev/msg456014.html
- add error returns when dma_map_single() failed
- clean up code structures
- clean up wait-loop and wake-queue conditions
- add ave_wdesc_addr() and offset definitions
- add ave_macaddr_init() to clean up mac-address operation
- fix checking whether Tx entry is not enough
- fix supported features of phydev
- add necessary free/disable operations
- add phydev check on ave_{get,set}_wol()
- remove netif_carrier functions, phydev initializer, and Tx budget check
- change obsolate codes
- replace ndev->{base_addr,irq} with the members of ave_private
- rename goto labels and mask definitions, and remove unused codes

Kunihiko Hayashi (2):
dt-bindings: net: add DT bindings for Socionext UniPhier AVE
net: ethernet: socionext: add AVE ethernet driver

.../bindings/net/socionext,uniphier-ave4.txt | 48 +
drivers/net/ethernet/Kconfig | 1 +
drivers/net/ethernet/Makefile | 1 +
drivers/net/ethernet/socionext/Kconfig | 22 +
drivers/net/ethernet/socionext/Makefile | 5 +
drivers/net/ethernet/socionext/sni_ave.c | 1744 ++++++++++++++++++++
6 files changed, 1821 insertions(+)
create mode 100644 Documentation/devicetree/bindings/net/socionext,uniphier-ave4.txt
create mode 100644 drivers/net/ethernet/socionext/Kconfig
create mode 100644 drivers/net/ethernet/socionext/Makefile
create mode 100644 drivers/net/ethernet/socionext/sni_ave.c

--
2.7.4