[PATCH v3 3/5] dt-bindings: at24: fix formatting and style

[Bartosz Golaszewski]

Make formatting and style consistent for the entire document.

This patch doesn't change the content of the binding.

Signed-off-by: Bartosz Golaszewski <brgl@xxxxxxxx>
Reviewed-by: Javier Martinez Canillas <javierm@xxxxxxxxxx>
---
 Documentation/devicetree/bindings/eeprom/at24.txt | 24 +++++++++++------------
 1 file changed, 12 insertions(+), 12 deletions(-)

diff --git a/Documentation/devicetree/bindings/eeprom/at24.txt b/Documentation/devicetree/bindings/eeprom/at24.txt
index 487e1005036c..7d4dc264b3cc 100644
--- a/Documentation/devicetree/bindings/eeprom/at24.txt
+++ b/Documentation/devicetree/bindings/eeprom/at24.txt
@@ -2,7 +2,7 @@ EEPROMs (I2C)
 
 Required properties:
 
-  - compatible: must be a "<manufacturer>,<model>" pair with one of the
+  - compatible: Must be a "<manufacturer>,<model>" pair with one of the
                 following values as fallback:
 
                 "atmel,24c00",
@@ -19,23 +19,23 @@ Required properties:
                 "atmel,24c512",
                 "atmel,24c1024"
 
-  - reg : the I2C address of the EEPROM
+  - reg: The I2C address of the EEPROM.
 
 Optional properties:
 
-  - pagesize : the length of the pagesize for writing. Please consult the
-               manual of your device, that value varies a lot. A wrong value
-	       may result in data loss! If not specified, a safety value of
-	       '1' is used which will be very slow.
+  - pagesize: The length of the pagesize for writing. Please consult the
+              manual of your device, that value varies a lot. A wrong value
+              may result in data loss! If not specified, a safety value of
+              '1' is used which will be very slow.
 
-  - read-only: this parameterless property disables writes to the eeprom
+  - read-only: This parameterless property disables writes to the eeprom.
 
-  - size: total eeprom size in bytes
+  - size: Total eeprom size in bytes.
 
-  - no-read-rollover:
-			This parameterless property indicates that the multi-address
-			eeprom does not automatically roll over reads to the next
-			slave address. Please consult the manual of your device.
+  - no-read-rollover: This parameterless property indicates that the
+                      multi-address eeprom does not automatically roll over
+                      reads to the next slave address. Please consult the
+                      manual of your device.
 
   - wp-gpios: GPIO to which the write-protect pin of the chip is connected.
 
-- 
2.15.1