Re: [RFC PATCH] blk-mq: fixup RESTART when queue becomes idle

[Bart Van Assche]

On Fri, 2018-01-19 at 15:34 +0800, Ming Lei wrote:
> Could you explain a bit when SCSI target replies with BUSY very often?
> 
> Inside initiator, we have limited the max per-LUN requests and per-host
> requests already before calling .queue_rq().

That's correct. However, when a SCSI initiator and target system are
communicating with each other there is no guarantee that initiator and target
queue depth have been tuned properly. If the initiator queue depth and the
number of requests that can be in flight according to the network protocol
are both larger than the target queue depth and if the target system uses
relatively slow storage (e.g. harddisks) then it can happen that the target
replies with BUSY often.

The Linux iSCSI initiator limits MaxOutstandingR2T (the number of requests
an initiator may sent without having received an answer from the target) to
one so I don't think this can happen when using iSCSI/TCP.

With the SRP initiator however the maximum requests that can be in flight
between initiator and target depends on the number of credits that were
negotiated during login between initiator and target. Some time ago I modified
the SRP initiator such that it limits the initiator queue depth to the number
of SRP credits minus one (for task management). That resulted in a performance
improvement due to fewer BUSY conditions at the initiator side (see also commit
7ade400aba9a ("IB/srp: Reduce number of BUSY conditions")). Another patch for
the SCST SRP target driver limited the number of SRP credits to the queue depth
of the block device at the target side. I'm referring to the following code:
ch->rq_size = min(MAX_SRPT_RQ_SIZE, scst_get_max_lun_commands(NULL, 0)) (I have
not yet had the time to port this change to LIO).

Without such tuning across initiator and target it can happen often that the
target system sends the reply "BUSY" back to the initiator. I think that's why
there is code in the SCSI core to automatically adjust the initiator queue
depth if the "BUSY" condition is encountered frequently. See also
scsi_track_queue_full().

Bart.