Re: [PATCH v6 00/41] ARM: davinci: convert to common clock frameworkâ

[Bartosz Golaszewski]

2018-01-25 13:53 GMT+01:00 Sekhar Nori <nsekhar@xxxxxx>:
> On Wednesday 24 January 2018 01:33 PM, Bartosz Golaszewski wrote:
>> 2018-01-23 21:23 GMT+01:00 David Lechner <david@xxxxxxxxxxxxxx>:
>>> On 01/23/2018 02:05 PM, David Lechner wrote:
>>>>
>>>> On 01/23/2018 02:01 PM, David Lechner wrote:
>>>>>
>>>>> On 01/23/2018 01:53 PM, Bartosz Golaszewski wrote:
>>>>>>
>>>>>>
>>>>>> In the mdio case - the problem is that devm_clk_get() doesn't fail,
>>>>>> but somehow the clock doesn't end up in the list of the device's
>>>>>> clocks - which is why it's not enabled by pm_runtime_get_sync().
>>>>>>
>>>>>
>>>>>
>>>>> Right. This is because devm_clk_get() now finds the clock via device
>>>>> tree instead of a clkdev lookup entry. However, I think that the PM
>>>>> notifier registered in arch/arm/mach-davinci/pm_domain.c only uses
>>>>> the clkdev lookup to match the con_id and does not use device tree.
>>>>> The same thing is happing in mdio, emac and lcdc.
>>>>>
>>>>
>>>> Minor correction: It looks like emac doesn't do this because it doesn't
>>>> have a con_id of "fck". But, the same clock is shared by emac and mdio, so
>>>> since mdio enables the clock, emac doesn't notice or care that it did
>>>> not enable the clock itself.
>>>
>>>
>>> How about using pm_clk_add_clk() in these drivers to explicitly use the
>>> clocks for power management instead of relying on pm_clk_add_notifier()
>>> to do this implicitly?
>>
>> Yes, this sounds good.
>
> Looking at how pm_clk_notify() in clock_ops.c uses con_id[] list, right
> now pm_runtime() will work only for clocks which have con_id (from the
> list above) mentioned in DT. Since clk_find() mandates con_id match when
> its available, NULL con_id does not match.
>
> For simple devices like DaVinci which uses just one clock for power
> management per device (multiple devices might share a clock, but not
> other way around as far as I recall, anyway I will double check this
> assertion), the attached patch should make EMAC work.
>

Tested on da850-lcdk - patch does indeex fix emac on da850-lcdk, but
tilcdc still complains.

> That still leaves why lcdc does not work. One difference is it uses
> PSC1. Are there other devices in PSC1 which work (just to rule out any
> thing wrong with PSC1 handling).
>

Emac uses PSC1 too.

GPIO and I2C1 work fine, but OHCI rarely lives through any cpufreq
transition. I'm still trying to figure out why it's dying.

Thanks,
Bartosz