Re: [PATCH v2 1/3] sched: Stop nohz stats when decayed

[Peter Zijlstra]

On Thu, Feb 08, 2018 at 04:05:58PM +0100, Vincent Guittot wrote:
> On 8 February 2018 at 15:00, Peter Zijlstra <peterz@xxxxxxxxxxxxx> wrote:
> > On Tue, Feb 06, 2018 at 08:23:05PM +0100, Vincent Guittot wrote:
> >
> >> @@ -9207,13 +9231,15 @@ void nohz_balance_enter_idle(int cpu)
> >>       if (!housekeeping_cpu(cpu, HK_FLAG_SCHED))
> >>               return;
> >>
> >> +     rq->has_blocked_load = 1;

Should we not set that with rq->lock held? We already clear it while
holding rq->lock.

> >> +
> >>       if (rq->nohz_tick_stopped)
> >> -             return;
> >
> > this case is difficult... needs thinking
> 
> The use case happens when a CPU wakes up and goes back to idle before
> the tick fires and clears nohz_tick_stopped.

Yes, and so we could have accrued blocked load. Now in this case the CPU
must already be set in the cpumask, but we could've already cleared
has_blocked.

My question is mostly about needing that "goto out" to set the flag,
because I think we can loose it on a store collision vs clearing it. But
in that case I suppose the iteration must already be in progress, which
in turn will observe rq->has_blocked_load and re-set nohz.has_blocked.

So yes, this is good, but could use a comment.

> > Without this ordering I think it would be possible to loose has_blocked
> > and not observe the CPU either.
> 
> I think that you are right.
> I also wondered if some barriers were necessary but wrongly concluded
> that set operation on nohz.idle_cpus_mask and WRITE_ONCE with volatile
> would be enough to ensure the right ordering

Yeah, so I forgot to write the comment in my patch, but it had the
barriers implied by cmpxchg.