Re: [PATCH] cpufreq: imx6q: support frequencies >528MHz for i.MX6UL/ULL

[Rafael J. Wysocki]

On Fri, Jan 19, 2018 at 12:58 AM, Stefan Agner <stefan@xxxxxxxx> wrote:
> Depending on SKU i.MX6UL/i.MX6ULL support frequencies up to 900MHz.
> Use PLL1 sys clock for all operating points higher than 528MHz.
>
> Note: For higher operating points VDD_SOC_IN needs to be 125mV
> higher than the ARM set-point (see datasheet). Specifically, the
> i.MX6UL/ULL EVK boards have an external DC regulator which needs
> adjustment. The regulator adjustment is not covered with this
> change.
>
> Signed-off-by: Stefan Agner <stefan@xxxxxxxx>

Can you please rebase this on top of 4.16-rc1?  It doesn't apply for me as is.

> ---
>  drivers/cpufreq/imx6q-cpufreq.c | 14 ++++++++------
>  1 file changed, 8 insertions(+), 6 deletions(-)
>
> diff --git a/drivers/cpufreq/imx6q-cpufreq.c b/drivers/cpufreq/imx6q-cpufreq.c
> index 628fe899cb48..840f6386c780 100644
> --- a/drivers/cpufreq/imx6q-cpufreq.c
> +++ b/drivers/cpufreq/imx6q-cpufreq.c
> @@ -114,12 +114,14 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index)
>                  */
>                 clk_set_rate(arm_clk, (old_freq >> 1) * 1000);
>                 clk_set_parent(pll1_sw_clk, pll1_sys_clk);
> -               if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> -                       clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> -               else
> -                       clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
> -               clk_set_parent(step_clk, secondary_sel_clk);
> -               clk_set_parent(pll1_sw_clk, step_clk);
> +               if (freq_hz <= clk_get_rate(pll2_bus_clk)) {
> +                       if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
> +                               clk_set_parent(secondary_sel_clk, pll2_bus_clk);
> +                       else
> +                               clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
> +                       clk_set_parent(step_clk, secondary_sel_clk);
> +                       clk_set_parent(pll1_sw_clk, step_clk);
> +               }
>         } else {
>                 clk_set_parent(step_clk, pll2_pfd2_396m_clk);
>                 clk_set_parent(pll1_sw_clk, step_clk);
> --
> 2.15.1
>