Re: [PATCH v8 1/2] dt-bindings: media: Add Allwinner V3s Camera Sensor Interface (CSI)

[Philipp Zabel]

On Tue, 2018-02-27 at 10:07 +0800, Yong Deng wrote:
> Add binding documentation for Allwinner V3s CSI.
> 
> Acked-by: Maxime Ripard <maxime.ripard@xxxxxxxxxxxxxxxxxx>
> Acked-by: Sakari Ailus <sakari.ailus@xxxxxxxxxxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> Signed-off-by: Yong Deng <yong.deng@xxxxxxxxxxxx>
> ---
>  .../devicetree/bindings/media/sun6i-csi.txt        | 59 ++++++++++++++++++++++
>  1 file changed, 59 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/media/sun6i-csi.txt
> 
> diff --git a/Documentation/devicetree/bindings/media/sun6i-csi.txt b/Documentation/devicetree/bindings/media/sun6i-csi.txt
> new file mode 100644
> index 000000000000..2ff47a9507a6
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/media/sun6i-csi.txt
> @@ -0,0 +1,59 @@
> +Allwinner V3s Camera Sensor Interface
> +-------------------------------------
> +
> +Allwinner V3s SoC features two CSI module. CSI0 is used for MIPI CSI-2
> +interface and CSI1 is used for parallel interface.
> +
> +Required properties:
> +  - compatible: value must be "allwinner,sun8i-v3s-csi"
> +  - reg: base address and size of the memory-mapped region.
> +  - interrupts: interrupt associated to this IP
> +  - clocks: phandles to the clocks feeding the CSI
> +    * bus: the CSI interface clock
> +    * mod: the CSI module clock
> +    * ram: the CSI DRAM clock
> +  - clock-names: the clock names mentioned above
> +  - resets: phandles to the reset line driving the CSI
> +
> +Each CSI node should contain one 'port' child node with one child 'endpoint'
> +node, according to the bindings defined in
> +Documentation/devicetree/bindings/media/video-interfaces.txt. As mentioned
> +above, the endpoint's bus type should be MIPI CSI-2 for CSI0 and parallel or
> +Bt656 for CSI1.
> +
> +Endpoint node properties for CSI1
> +---------------------------------
> +
> +- remote-endpoint	: (required) a phandle to the bus receiver's endpoint
> +			   node
> +- bus-width:		: (required) must be 8, 10, 12 or 16
> +- pclk-sample		: (optional) (default: sample on falling edge)

It would be helpful to state that 1 is rising edge and 0 is falling
edge, see for example ov5640.txt

regards
Philipp