Re: [PATCH] spi: atmel: init FIFOs before spi enable

[Nicolas Ferre]

On 27/02/2018 at 11:25, Eugen Hristev wrote:
> The datasheet recommends initializing FIFOs before
> SPI enable. If we do not do it like this, there may be
> a strange behavior. We noticed that DMA does not work properly
> with FIFOs if we do not clear them beforehand or enable them
> before SPIEN.
>
> Signed-off-by: Eugen Hristev <eugen.hristev@xxxxxxxxxxxxx>

Ok, good:
Acked-by: Nicolas Ferre <nicolas.ferre@xxxxxxxxxxxxx>

> ---
>   drivers/spi/spi-atmel.c | 8 +++++---
>   1 file changed, 5 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
> index 6694709..0478758 100644
> --- a/drivers/spi/spi-atmel.c
> +++ b/drivers/spi/spi-atmel.c
> @@ -1489,6 +1489,11 @@ static void atmel_spi_init(struct atmel_spi *as)
>   {
>   	spi_writel(as, CR, SPI_BIT(SWRST));
>   	spi_writel(as, CR, SPI_BIT(SWRST)); /* AT91SAM9263 Rev B workaround */
> +
> +	/* It is recommended to enable FIFOs first thing after reset */
> +	if (as->fifo_size)
> +		spi_writel(as, CR, SPI_BIT(FIFOEN));
> +
>   	if (as->caps.has_wdrbt) {
>   		spi_writel(as, MR, SPI_BIT(WDRBT) | SPI_BIT(MODFDIS)
>   				| SPI_BIT(MSTR));
> @@ -1499,9 +1504,6 @@ static void atmel_spi_init(struct atmel_spi *as)
>   	if (as->use_pdc)
>   		spi_writel(as, PTCR, SPI_BIT(RXTDIS) | SPI_BIT(TXTDIS));
>   	spi_writel(as, CR, SPI_BIT(SPIEN));
> -
> -	if (as->fifo_size)
> -		spi_writel(as, CR, SPI_BIT(FIFOEN));
>   }
>   
>   static int atmel_spi_probe(struct platform_device *pdev)


--
Nicolas Ferre