Re: [PATCH v2] ARM: imx: avic: set low-power interrupt mask for imx25

[Shawn Guo]

On Tue, Feb 27, 2018 at 10:29:15PM +0100, Martin Kaiser wrote:
> imx25 contains two registers (LPIMR0 and 1) to define which interrupts
> are enabled in low-power mode. As of today, those two registers are
> configured to enable all interrupts. Before going to low-power mode, the
> AVIC's INTENABLEH and INTENABLEL registers are configured to enable only
> those interrupts which are used as wakeup sources.
> 
> It turned out that this approach is not sufficient if we want the imx25
> to go into stop mode during suspend-to-ram. (Stop mode is the low-power
> mode that consumes the least power. The peripheral master clock is
> switched off in this mode). For stop mode to work, the LPIMR0 and 1
> registers have to be configured with the set of interrupts that are
> allowed in low-power mode. Fortunately, the bits in the LPIMR registers
> are assigned to the same interrupts as the bits in INTENABLEH and
> INTENABLEL. However, LPIMR uses 1 to mask an interrupt whereas the
> INTENABLE registers use 1 to enable an interrupt.
> 
> This patch sets the LPIMR registers to the inverted bitmask of the
> INTENABLE registers during suspend and goes back to "all interrupts
> masked" when we wake up again. We also make this the default at startup.
> 
> As far as I know, the other supported imx architectures have no similar
> mechanism. Since the LPIMR registers are part of the CCM module, we
> query the device tree for an imx25 ccm node in order to detect if we're
> running on imx25.
> 
> Signed-off-by: Martin Kaiser <martin@xxxxxxxxx>

Applied, thanks.