[PATCH v2 1/4] dt-bindings: mfd: bd9571mwv: Document DDR Backup Mode properties

[Geert Uytterhoeven]

Document the new optional properties related to DDR Backup Mode and
toggle/momentary power switches.

Signed-off-by: Geert Uytterhoeven <geert+renesas@xxxxxxxxx>
---
v2:
  - Improve property description,
  - Add properties for power switch type.
---
 Documentation/devicetree/bindings/mfd/bd9571mwv.txt | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)

diff --git a/Documentation/devicetree/bindings/mfd/bd9571mwv.txt b/Documentation/devicetree/bindings/mfd/bd9571mwv.txt
index 9ab216a851d5619b..8804a214759845c5 100644
--- a/Documentation/devicetree/bindings/mfd/bd9571mwv.txt
+++ b/Documentation/devicetree/bindings/mfd/bd9571mwv.txt
@@ -25,6 +25,25 @@ Required properties:
 			    Each child node is defined using the standard
 			    binding for regulators.
 
+Optional properties:
+  - rohm,ddr-backup-power : Value to use for DDR-Backup Power (default 0).
+			    This is a bitmask that specifies which DDR power
+			    rails need to be kept powered when backup mode is
+			    entered, for system suspend:
+			      - bit 0: DDR0
+			      - bit 1: DDR1
+			      - bit 2: DDR0C
+			      - bit 3: DDR1C
+			    These bits match the KEEPON_DDR* bits in the
+			    documentation for the "BKUP Mode Cnt" register.
+  - rohm,rstbmode-level: The RSTB signal is configured for level mode, to
+			 accommodate a toggle power switch (the RSTBMODE pin is
+			 strapped low).
+  - rohm,rstbmode-pulse: The RSTB signal is configured for pulse mode, to
+			 accommodate a momentary power switch (the RSTBMODE pin
+			 is strapped high).
+			 The two properties above are mutually exclusive.
+
 Example:
 
 	pmic: pmic@30 {
@@ -36,6 +55,8 @@ Example:
 		#interrupt-cells = <2>;
 		gpio-controller;
 		#gpio-cells = <2>;
+		rohm,ddr-backup-power = <15>;
+		rohm,rstbmode-pulse;
 
 		regulators {
 			dvfs: dvfs {
-- 
2.7.4