Re: [PATCH v10] mmc: Export host capabilities to debugfs.
From: Ulf Hansson
Date: Thu Mar 15 2018 - 06:13:03 EST
On 13 March 2018 at 06:10, Harish Jenny K N <harish_kandiga@xxxxxxxxxx> wrote:
> This patch exports the host capabilities to debugfs
>
> This idea of sharing host capabilities over debugfs
> came up from Abbas Raza <Abbas_Raza@xxxxxxxxxx>
> Earlier discussions:
> https://lkml.org/lkml/2018/3/5/357
> https://www.spinics.net/lists/linux-mmc/msg48219.html
>
> Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxxxxxxxx>
> Signed-off-by: Harish Jenny K N <harish_kandiga@xxxxxxxxxx>
> ---
>
> Changes in v10:
> - minor review comment addressed.
> - Added "Reviewed-by" line
>
> Changes in v9
> - More code cleanup as suggested by Andy Shevchenko.
>
> Changes in v8
> - Changes to use for_each_set_bit as suggested by Andy Shevchenko.
>
> Changes in v7
> - Moved additional capabilities also to caps file as mentioned by Ulf Hansson
> - compacting the code with macros
>
> Changes in v6:
> - Used DEFINE_SHOW_ATTRIBUTE
>
> Changes in v5:
> - Added parser logic in kernel by using debugfs_create_file for caps and caps2 instead of debugfs_create_x32
> - Changed Author
>
> Changes in v4:
> - Moved the creation of nodes to mmc_add_host_debugfs
> - Exported caps2
> - Renamed host_caps to caps
>
> Changes in v3:
> - Removed typecasting of &host->caps to (u32 *)
>
> Changes in v2:
> - Changed Author
>
> drivers/mmc/core/debugfs.c | 107 +++++++++++++++++++++++++++++++++++++++++++++
> 1 file changed, 107 insertions(+)
>
> diff --git a/drivers/mmc/core/debugfs.c b/drivers/mmc/core/debugfs.c
> index c51e0c0..826d361 100644
> --- a/drivers/mmc/core/debugfs.c
> +++ b/drivers/mmc/core/debugfs.c
> @@ -225,6 +225,110 @@ static int mmc_clock_opt_set(void *data, u64 val)
> DEFINE_SIMPLE_ATTRIBUTE(mmc_clock_fops, mmc_clock_opt_get, mmc_clock_opt_set,
> "%llu\n");
>
> +/*
> + * mmc_host_capabilities - MMC host capabilities
> + *
> + * This must be in sync with caps definitions in the mmc/host.h
> + */
> +static const char * const mmc_host_capabilities[] = {
> + "4-bit transfers allowed",
> + "Supports MMC high-speed timing",
> + "Supports SD high-speed timing",
> + "Can signal pending SDIO IRQs",
> + "Talks only SPI protocols",
> + "Needs polling for card-detection",
> + "8 bit transfers allowed",
> + "Suspends (e)MMC/SD at idle",
> + "Nonremovable",
> + "Waits while card is busy",
> + "Allows erase/trim commands",
> + "Supports DDR mode at 3.3V",
> + "Supports DDR mode at 1.8V",
> + "Supports DDR mode at 1.2V",
> + "Can power off after boot",
> + "CMD14/CMD19 bus width ok",
> + "Supports UHS SDR12 mode",
> + "Supports UHS SDR25 mode",
> + "Supports UHS SDR50 mode",
> + "Supports UHS SDR104 mode",
> + "Supports UHS DDR50 mode",
> + "Unknown (bit 21)",
> + "Unknown (bit 22)",
> + "Supports Driver Type A",
> + "Supports Driver Type C",
> + "Supports Driver Type D",
> + "Unknown (bit 26)",
> + "RW reqs can be completed within mmc_request_done()",
> + "Supports Enable card detect wake",
> + "Can send commands during data transfer",
> + "CMD23 supported",
> + "Supports Hardware reset"
> +};
> +
> +/*
> + * mmc_host_capabilities2 - MMC host additional capabilities
> + *
> + * This must be in sync with caps2 definitions in the mmc/host.h
> + */
> +static const char * const mmc_host_capabilities2[] = {
> + "No access to Boot partition",
> + "Unknown (bit 1)",
> + "Can do full power cycle",
> + "Unknown (bit 3)",
> + "Unknown (bit 4)",
> + "Supports HS200 1.8V SDR",
> + "Supports HS200 1.2V SDR",
> + "Unknown (bit 7)",
> + "Unknown (bit 8)",
> + "Unknown (bit 9)",
> + "Card-detect signal active high",
> + "Write-protect signal active high",
> + "Unknown (bit 12)",
> + "Unknown (bit 13)",
> + "Can do complete power cycle of the card",
> + "Supports HS400 1.8V",
> + "Support HS400 1.2V",
> + "SDIO IRQ - Nothread",
> + "No physical write protect pin, assume always read-write",
> + "Do not send SDIO commands during initialization",
> + "Supports enhanced strobe",
> + "Do not send SD commands during initialization",
> + "Do not send (e)MMC commands during initialization",
> + "Has eMMC command queue engine",
> + "CQE can issue a direct command",
> + "Unknown (bit 25)",
> + "Unknown (bit 26)",
> + "Unknown (bit 27)",
> + "Unknown (bit 28)",
> + "Unknown (bit 29)",
> + "Unknown (bit 30)",
> + "Unknown (bit 31)"
> +};
Honestly, I don't like this, but maybe other people do, then I am fine
with this approach.
If were to decide, I would just rather print the caps field in a
hexadecimal bit form and leave the translation to the user.
> +
> +static int mmc_caps_show(struct seq_file *s, void *unused)
> +{
> + struct mmc_host *host = s->private;
> + unsigned long caps = host->caps;
> + unsigned long caps2 = host->caps2;
> + int bit;
> +
> + seq_puts(s, "MMC Host capabilities are:\n");
> + seq_puts(s, "=============================================\n");
> +
> + for_each_set_bit(bit, &caps, ARRAY_SIZE(mmc_host_capabilities))
> + seq_printf(s, "%s\n", mmc_host_capabilities[bit]);
> +
> + seq_puts(s, "=============================================\n");
> + seq_puts(s, "MMC Host additional capabilities are:\n");
> + seq_puts(s, "=============================================\n");
> +
> + for_each_set_bit(bit, &caps2, ARRAY_SIZE(mmc_host_capabilities2))
> + seq_printf(s, "%s\n", mmc_host_capabilities2[bit]);
> +
> + return 0;
> +}
> +DEFINE_SHOW_ATTRIBUTE(mmc_caps);
> +
> void mmc_add_host_debugfs(struct mmc_host *host)
> {
> struct dentry *root;
> @@ -243,6 +347,9 @@ void mmc_add_host_debugfs(struct mmc_host *host)
> if (!debugfs_create_file("ios", S_IRUSR, root, host, &mmc_ios_fops))
> goto err_node;
>
> + if (!debugfs_create_file("caps", 0400, root, host, &mmc_caps_fops))
> + goto err_node;
> +
> if (!debugfs_create_file("clock", S_IRUSR | S_IWUSR, root, host,
> &mmc_clock_fops))
> goto err_node;
> --
> 1.9.1
>
Kind regards
Uffe