Re: [PATCH v2 1/4] media: i2c: Copy mt9t112 soc_camera sensor driver

[jacopo mondi]

Hi Hans,

On Thu, Mar 15, 2018 at 08:30:21AM -0700, Hans Verkuil wrote:
> On 03/15/2018 07:38 AM, jacopo mondi wrote:
> > Hi Sakari,
> >    thanks for looking into this!
> >
> > On Thu, Mar 15, 2018 at 01:35:34PM +0200, Sakari Ailus wrote:
> >> Hi Jacopo,
> >>
> >> I wonder if it'd make sense to just make all the changes to the driver and
> >> then have it reviewed; I'm not sure the old driver can be said to have been
> >> in a known-good state that'd be useful to compare against. I think you did
> >> that with another driver as well.
> >>
> >
> > Well, I understand this is still debated, and I see your point.
> > As far as I can tell the driver had been developed to work with SH4
> > Ecovec boards and there tested.
> >
> > I'm not sure I fully got you here though. Are you proposing to
> > squash my next patch that cleans up the driver into this one and
> > propose it as a completely new driver to be reviewed from scratch?
> >
> > In the two previous driver I touched in this "remove soc_camera"
> > journey (ov772x and tw9910) I have followed this same pattern: copy
> > the soc_camera driver without removing the existing one, and pile on
> > top my changes/cleanups in another patch. Then port the board code to
> > use the new sensor driver, and the new CEU driver as well.
> >
> > Also, how would you like to proceed here? Hans sent a pull request for
> > the series, should I go with incremental changes on top of this?
>
> I don't want to postpone this conversion. The i2c/mt9t112.c is bug-compatible
> with i2c/soc-camera/mt9t112.c which is good enough for me. Being able to
> remove soc-camera in the (hopefully very) near future is the most important
> thing here.
>
> Once Jacopo can actually test the sensor, then that's a good time to review
> the driver in more detail.
>
> This reminded me that I actually started testing this sensor a year
> ago (I bought the same sensor on ebay, I completely forgot about that!).
>
> My attempt is here:
>
> https://git.linuxtv.org/hverkuil/media_tree.git/log/?h=mt9t112
>
> I never finished it because I had no documentation on the pinout and never
> got around to hooking my oscilloscope up to it to figure this out. I was
> testing this with the atmel-isc.c driver.
>
> This might be of some use to you, Jacopo, once you have the sensor.

Thanks for the info. I'll see what I can do. I don't have register
level document, and if the module is the same you have neither a
pinout description. This is going to be fun :/

I'll then refrain from sending more patches for this series/driver
until we cannot actually test the sensor, fixes apart, if any, of course.

Thanks
   j

>
> Regards,
>
> 	Hans

Attachment: signature.asc
Description: PGP signature