Re: [PATCH 4/6] phy: qcom-qmp: Add QMP V3 USB3 UNI PHY support for sdm845

[Evan Green]

On Tue, Mar 20, 2018 at 12:00 AM Manu Gautam <mgautam@xxxxxxxxxxxxxx> wrote:

> Hi,


> On 3/19/2018 11:21 PM, Evan Green wrote:
> > Hi Manu,
> >
> > On Fri, Mar 16, 2018 at 2:46 AM Manu Gautam <mgautam@xxxxxxxxxxxxxx>
wrote:
> [snip]
> >> index d1c6905..5d78d43 100644
> >> --- a/drivers/phy/qualcomm/phy-qcom-qmp.h
> >> +++ b/drivers/phy/qualcomm/phy-qcom-qmp.h
> >> @@ -214,6 +214,8 @@
> >>   #define QSERDES_V3_RX_UCDR_FASTLOCK_FO_GAIN            0x030
> >>   #define QSERDES_V3_RX_UCDR_SO_SATURATION_AND_ENABLE    0x034
> >>   #define QSERDES_V3_RX_RX_TERM_BW                       0x07c
> >> +#define QSERDES_V3_RX_VGA_CAL_CNTRL1                   0x0bc
> > I noticed you add this definition, but never use it. Are you missing a
> > QMP_PHY_INIT_CFG line for this register in qmp_v3_usb3_uniphy_rx_tbl[],
or
> > is that register "don't care"? It looks important, and while its default
> > value out of reset might be valid, you never know what nutty value boot
> > firmware might set it to.
> >

> Yes POR value of this register is valid for this soc.
> QMP driver resets (asserts and de-asserts reset_control) in probe. So,
that should
> ensure that PHY registers are indeed set to POR value. Left the
definition there
> if different setting needed to be done for a different variant of h/w in
future.

Sounds good. Thanks, Manu.

Reviewed-by: Evan Green <evgreen@xxxxxxxxxxxx>