Re: [PATCH v3 11/11] dt-bindings: gpio: Add bindings for Cadence I3C gpio expander

From: Boris Brezillon
Date: Mon Mar 26 2018 - 07:25:47 EST


On Mon, 26 Mar 2018 12:12:54 +0200
Geert Uytterhoeven <geert@xxxxxxxxxxxxxx> wrote:

> Hi Boris,
>
> On Fri, Mar 23, 2018 at 12:00 PM, Boris Brezillon
> <boris.brezillon@xxxxxxxxxxx> wrote:
> > Document the Cadence I3C gpio expander bindings.
> >
> > Signed-off-by: Boris Brezillon <boris.brezillon@xxxxxxxxxxx>
>
> Thanks for your patch!
>
> > --- /dev/null
> > +++ b/Documentation/devicetree/bindings/gpio/gpio-cdns-i3c.txt
>
> > +- #interrupt-cells : Should be 2. The first cell is the GPIO number.
> > + The second cell bits[3:0] is used to specify trigger type and level flags:
> > + 1 = low-to-high edge triggered.
> > + 2 = high-to-low edge triggered.
> > + 3 = triggered on both edges.
> > + 4 = active high level-sensitive.
> > + 8 = active low level-sensitive.
>
> These are identical to the values in <dt-bindings/interrupt-controller/irq.h>.
> Perhaps you can refer to those definitions?

Well, I'm not sure this is allowed since DT bindings docs are
supposed to be OS-agnostic and macros defined in
<dt-bindings/interrupt-controller/irq.h> are, AFAIK, only available to
Linux.

Note that I copied these definitions from another binding ;-).

Rob, any opinion?


--
Boris Brezillon, Bootlin (formerly Free Electrons)
Embedded Linux and Kernel engineering
https://bootlin.com