Re: [linux-sunxi] [PATCH v9 0/2] Initial Allwinner V3s CSI Support
From: Yong
Date: Wed Mar 28 2018 - 21:03:24 EST
Hi,
On Wed, 28 Mar 2018 16:29:47 -0700
Martin Kelly <mkelly@xxxxxxxx> wrote:
> On 03/05/2018 05:51 PM, Yong Deng wrote:
> > This patchset add initial support for Allwinner V3s CSI.
> >
> > Allwinner V3s SoC features two CSI module. CSI0 is used for MIPI CSI-2
> > interface and CSI1 is used for parallel interface. This is not
> > documented in datasheet but by test and guess.
> >
> > This patchset implement a v4l2 framework driver and add a binding
> > documentation for it.
> >
> > Currently, the driver only support the parallel interface. And has been
> > tested with a BT1120 signal which generating from FPGA. The following
> > fetures are not support with this patchset:
> > - ISP
> > - MIPI-CSI2
> > - Master clock for camera sensor
> > - Power regulator for the front end IC
> >
>
> Hi Yong,
>
> Thanks so much, this driver is a great contribution!
>
> Unfortunately the board I'm working with (nanopi neo air) uses the MIPI
> CSI-2 CSI0 interface rather than CSI1. Do you have any plans to support
> the MIPI CSI-2 interface at some point? If not, do you know the scope of
> what would be involved?
AFAIK, there is no document about MIPI CSI-2. You can take a look at the
source code in BSP:
https://github.com/friendlyarm/h3_lichee/tree/master/linux-3.4/drivers/media/video/sunxi-vfe/mipi_csi
And try to port it to mainline.
Thanks,
Yong