[PATCHv4 03/10] mfd: ti-lmu: use managed resource for everything
From: Sebastian Reichel
Date: Fri Mar 30 2018 - 13:26:49 EST
This replaces all remaining unmanaged resources with device
managed ones, so that the remove function is no longer needed.
This makes the code slightly shorter and fixes two problems:
1. The hardware is disabled after the child devices have
been removed. Previously there was a potential race
condition.
2. The hardware is disabled when mfd_add_devices fails
during probe.
Signed-off-by: Sebastian Reichel <sebastian.reichel@xxxxxxxxxxxxxxx>
---
drivers/mfd/ti-lmu.c | 21 ++++++++-------------
1 file changed, 8 insertions(+), 13 deletions(-)
diff --git a/drivers/mfd/ti-lmu.c b/drivers/mfd/ti-lmu.c
index e14cb9f41b44..2ee09d099832 100644
--- a/drivers/mfd/ti-lmu.c
+++ b/drivers/mfd/ti-lmu.c
@@ -47,8 +47,9 @@ static int ti_lmu_enable_hw(struct ti_lmu *lmu, enum ti_lmu_id id)
return 0;
}
-static void ti_lmu_disable_hw(struct ti_lmu *lmu)
+static void ti_lmu_disable_hw(void *data)
{
+ struct ti_lmu *lmu = data;
if (lmu->en_gpio)
gpiod_set_value(lmu->en_gpio, 0);
}
@@ -205,6 +206,10 @@ static int ti_lmu_probe(struct i2c_client *cl, const struct i2c_device_id *id)
if (ret)
return ret;
+ ret = devm_add_action_or_reset(dev, ti_lmu_disable_hw, lmu);
+ if (ret)
+ return ret;
+
/*
* Fault circuit(open/short) can be detected by ti-lmu-fault-monitor.
* After fault detection is done, some devices should re-initialize
@@ -214,17 +219,8 @@ static int ti_lmu_probe(struct i2c_client *cl, const struct i2c_device_id *id)
i2c_set_clientdata(cl, lmu);
- return mfd_add_devices(lmu->dev, 0, data->cells,
- data->num_cells, NULL, 0, NULL);
-}
-
-static int ti_lmu_remove(struct i2c_client *cl)
-{
- struct ti_lmu *lmu = i2c_get_clientdata(cl);
-
- ti_lmu_disable_hw(lmu);
- mfd_remove_devices(lmu->dev);
- return 0;
+ return devm_mfd_add_devices(lmu->dev, 0, data->cells,
+ data->num_cells, NULL, 0, NULL);
}
static const struct i2c_device_id ti_lmu_ids[] = {
@@ -240,7 +236,6 @@ MODULE_DEVICE_TABLE(i2c, ti_lmu_ids);
static struct i2c_driver ti_lmu_driver = {
.probe = ti_lmu_probe,
- .remove = ti_lmu_remove,
.driver = {
.name = "ti-lmu",
.of_match_table = ti_lmu_of_match,
--
2.16.2