Re: [RESEND PATCH v6 2/5] dt-bindings: pwm-backlight: add PWM delay proprieties.

[Lee Jones]

On Wed, 28 Mar 2018, Enric Balletbo i Serra wrote:

> Hardware needs a delay between setting an initial (non-zero) PWM and
> enabling the backlight using GPIO. The post-pwm-on-delay-ms specifies
> this delay in milli seconds. Hardware also needs a delay between disabing
> the backlight using GPIO and setting PWM value to 0. The pwm-off-delay-ms
> is this delay in milli seconds.
> 
> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@xxxxxxxxxxxxx>
> Acked-by: Pavel Machek <pavel@xxxxxx>
> Acked-by: Thierry Reding <thierry.reding@xxxxxxxxx>
> Acked-by: Daniel Thompson <daniel.thompson@xxxxxxxxxx>
> Reviewed-by: Rob Herring <robh@xxxxxxxxxx>
> ---
> Based on the original Huang Lin <hl@xxxxxxxxxxxxxx> work.
> Changes since v5:
>  - Add Acked-by: Thierry Reding <thierry.reding@xxxxxxxxx>
>  - CC DT mainling list (for some reason dropped at some point, my
>    fault)
> Changes since v4:
>  - Rebase on top of mainline.
> Changes since v3:
>  - Replace us for ms.
>  - Add Acked-by: Pavel Machek <pavel@xxxxxx>
> Changes since v2:
>  - Use separate properties (Rob Herring)
> Changes since v1:
>  - As suggested by Daniel Thompson
>    - Do not assume power-on delay and power-off delay will be the same
> ---
>  Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt | 6 ++++++
>  1 file changed, 6 insertions(+)

Applied, thanks.

-- 
Lee Jones [æçæ]
Linaro Services Technical Lead
Linaro.org â Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog